Type in the full discussion title or a part of it.
Discussion Title Created date
Avr studio with stk500 on imac with snow leopard?
I am planing to buy imac and stop using windows. It is possible to install and run with out problems avrstudio on mac with leopard snow? I am using stk500 hardware. If it is not...
Saturday, 26 December 2009 - 12:26
lcd amber dot on black backround were?
I am searching on line shop to buy 2x20 or 2x16 lcd character module with red dot on black backround. Can someone suggest a shop? I fount only one module that work with 3.3v data...
Sunday, 11 October 2009 - 21:50
How to ror and lsr in c?
Hello I try to read the value from adc and then appear it on lcd I have drive the lcd I have read the adcl and adch but I canot appear it in lcd with ascii character I take...
Friday, 26 December 2008 - 22:58
Give some directions how to build my project
I would like to construct a new instrument (tester)to measure pressure in engine with motorola pressure sensor. First of all what this program have to do. The program must read 3...
Wednesday, 10 December 2008 - 14:25
programming avr with c pdf book?
Well I programming avr with assembly for many years,little projects,now is time to make more complicating projects like oscillators with graphic displays,touch screens , interface...
Wednesday, 26 November 2008 - 08:06
How to read water temp. sensor
I would like to read the water temp sensor from my car. This sensor is like ntc in 20 c have 2.2-2.7 kohm and on 80 c have 290-350 ohm. How I can convert the resistance of this...
Saturday, 7 July 2007 - 22:46
Do I have to connect the reset pin if I not use ext w.dog?
In some projects I dont use external watch dog timer so I leave the reset pin on air is that correct? or I have to use a circuit for reset like resistor with capacitor or...
Friday, 6 July 2007 - 10:35
How to approximation analog input value.
I have build digital temperature controller with lm50. Everything work fine but I have a annoynig problem,when the temperature rise or fall of 1 celcius I dont have a stable...
Tuesday, 10 April 2007 - 10:59
How to interface graphic display with out controller?
Please help me. By mistake I order this graphic lcd http://www.powertip.com.tw/produ... This lcd didnt have controller.I have to order the PG320240-D who have controller.Any way...
Tuesday, 12 December 2006 - 10:38
Assembler error 129 branch out of reach
I use avr studio version 4.12.460. I write a program to mega8 and if I call a subroutine after many commands I cannot build my program because assembler found error ( (129):...
Wednesday, 8 November 2006 - 19:14
What I am doing wrong and I can not read the analog input?
I use the mega8 to read lm50 temperature sensor. I have use the same sensor in other device like 8535 and work fine. So I have connect the out of lm50 to adc0 pin 23 of mega8 (...
Monday, 30 October 2006 - 23:44
how to connect transistor to atmel port?
I would like to connect npn transistor to one port from avr atmega8. I use npn because I want to use ground to close a relay. My question is what value of resistor I have to use....
Sunday, 28 May 2006 - 18:35

Pages