Type in the full discussion title or a part of it.
Discussion Title Created date
Is there a devices list supported by each version of Studio?
title says it all
Sunday, 6 December 2015 - 02:02
Studio 4.19 build 730 on Windows 10
I like Studio 4, sorry.  It has support for devices I still have 1000's of, which have disappeared from the devices support of newer versions of studio.  I have a STK500...
Sunday, 29 November 2015 - 15:07
softening incandescent inrush current for relay contacts
For a 12 VDC incandescent lamp total load of about 4.8A at steady state, there's an initial cold filament turn-on inrush current draw of maybe 50A until the filaments heat....
Saturday, 29 March 2014 - 18:28
cat feeder hack, suggest a power conserving approach
My cat is basically a gorge and puke kind of cat. We need to smooth his feeding out... to prevent gorging, and it's wearing on us to feed little amounts every 2 hours. But...
Sunday, 23 March 2014 - 14:33
mothership mentions avrfreaks
We get an honorable mention by the mothership http://www.atmel.com/about/news/release.aspx?reference=tcm:26-51435 "..tinue to be the MCU of choice both for professional engineers...
Friday, 6 December 2013 - 15:20
strange dual relay slow release issue
I have a tiny12 (5v) driving 2 outputs to control two smallish 12v relays. I use a dual-NPN digital transistor package (built-in resistors) from ROHM on two I/O pins to pull down...
Wednesday, 25 September 2013 - 04:18
Does 6pin ICSP header offer everything I need atmega328P?
.. in the old days of AVR there were some things you needed to do that only parallel programming could handle, like blow a fuse. Which created an impossibility once the chip was...
Monday, 21 September 2009 - 17:27
OT: what is a "servo" if not a motor?
Servo usually means ..those funny little motors. But I've seen reference to servo in electronics which have nothing to do with motors.. "synchronize the servo [ in the sensor...
Saturday, 28 May 2005 - 04:35
power consumed in RESET state?
What parameter in the spec am I looking for: I want to know the power consumed by the AVR while held in RESET state. I presume this means all the pins are tri-stated.. further,...
Thursday, 17 March 2005 - 17:28
Safe to change EEAR immediately following reading EEDR?
The subject almost says it all.. Is it OK to have the following instructions in succession without any time passing between commands, regardless of clock speed? Is the value...
Thursday, 17 March 2005 - 06:26
89C2051 (yuck) UART to AVR (yum)
OK, I've got a 89C2051 UART Tx pin shifting out bytes at 9600-8-N-1 and I just want to know if I can tie that pin directly to a '2313 UART Rx pin? I only need half duplex. I'd...
Friday, 11 March 2005 - 23:29
will this Freak step forward?
Or should I say "scoot forward", check out this too cool Segway-on-a-budget with AVR at the heart: http://www.tlb.org/scooter.html Who dun it? Scott
Tuesday, 8 March 2005 - 14:24

Pages