Post Created date
AS7.0.2389 Pickit4 and Snap support
Not familiar with DFPs. Just started using Studio.
Wednesday, 2 October 2019 - 00:03
AS7.0.2389 Pickit4 and Snap support
I recently got a Snap, works both in MPLab X IPE vv2.25 and Atmel Studio 7 v7.0.2389. Windows 7   I removed R48, added 4K7 between J4 pin 2 and 4. In Tools/Options/Tools Set...
Tuesday, 1 October 2019 - 21:56
using PB5(reset) and PB4(clk0) as output in tiny 45
I’m not sure about the Tiny45, but IIRC, on the Tiny 12 & 15, the reset pin is open drain when used as an I/O pin. Check the ‘Port Function’ section of the datasheet.
Tuesday, 18 April 2006 - 14:01
atmega16 UART
sparksandtabs wrote:I was asking for a code that was ready for me to just pop in to the compiler and burn into my AVR. You have made that clear, unfortunately you keep using the...
Saturday, 15 April 2006 - 18:07
What can I improve in this schematic?
3. Don’t get creative with Li-Poly battery charging. Requirements are very specific and deviation can cause batteries to burst into flames. Carefully read data sheets for the...
Thursday, 13 April 2006 - 12:35
ATtiny26 No self proramming ?
source0ferror is correct. No SPM command listed in the datasheet
Thursday, 13 April 2006 - 00:16
Timers and interupts, how i use them???
Read the Timer section of the data sheet. Set up a timer to interrupt every 2 seconds. When you get an external interrupt, increment your count. When the timer overflows, output...
Thursday, 13 April 2006 - 00:08
ATtiny26 No self proramming ?
Can’t use a boot loader?
Wednesday, 12 April 2006 - 23:51
Apps work in BASCOM but not GCC
OliMeg32 wrote:Still don't know why AVRStudio won't recognise my board on its serial cable - I know the board is okay (can program through parallel) and I know the serial is okay...
Wednesday, 12 April 2006 - 23:45
connecting pins to wires on ATmega8
nleahcim wrote:It's quite possible to solder wire wrap wire to the pads on a MLF. You'll probabaly want to put some hot glue over the connections as otherwise they'll be pretty...
Wednesday, 12 April 2006 - 23:31
Fastest AVR inturrupt timer
jonH wrote:What I'm doing is clocking a device a specific number of times(cnt). I need the pulses(GSCLK) frequency to be as fast as possible and keep up with the number of time...
Wednesday, 12 April 2006 - 23:23
Apps work in BASCOM but not GCC
Better yet, check out some of the code in the Tutorial section of this site, and look at the examples that come with AVR GCC. You have installed AVR GCC (or what ever its called...
Wednesday, 12 April 2006 - 23:01

Pages