Post Created date
Trampoline Help
There's quite a few topics discussing this; these ones for example: https://www.avrfreaks.net/index.p... and https://www.avrfreaks.net/index.p... Basically the boot loader is...
Friday, 13 May 2011 - 08:25
Windows 7
Is your java VM up to date? Does this occur during installation or at run time? Can you give some more details on when/where it actually brakes?
Friday, 13 May 2011 - 08:17
Implementing MikroC/OS in AVR32UC3B0256 (EVK1101 board)
The OS is running in supervisor mode, while tasks are run in application mode. The scall instruction is when the jump to supervisor mode is done. It appears like the task isn't...
Tuesday, 10 May 2011 - 08:41
Implementing MikroC/OS in AVR32UC3B0256 (EVK1101 board)
Glad to hear you found where the problem is. So it never returns from BSP_PM_ClkSwitch(AVR32_PM_MCSEL_OSC0)? Without haven seen the src, the function is most likely to change the...
Wednesday, 4 May 2011 - 10:06
Implementing MikroC/OS in AVR32UC3B0256 (EVK1101 board)
You're programming to 0x80002000, that's correct. That's the offset and thus the application is programmed to the right place. The linker script is found in src /...
Wednesday, 4 May 2011 - 07:09
Implementing MikroC/OS in AVR32UC3B0256 (EVK1101 board)
Are you sure you're linking to 0x80002000? If you program a binary linked to 0x80000000 and then run it from 0x80002000 it will fail.
Tuesday, 3 May 2011 - 09:59
AVR, WiFi, and web server?
atmel.com/wifi
Monday, 2 May 2011 - 14:22
Implementing MikroC/OS in AVR32UC3B0256 (EVK1101 board)
If you use the DFU bootloader to upload your code; you should link it to 0x80002000. To remove the bootloader you use the command chiperase, but then you will not have any means...
Monday, 2 May 2011 - 08:10
Implementing MikroC/OS in AVR32UC3B0256 (EVK1101 board)
The CPU will start execution at 0x80000000 upon reset. The bootloader is factory programmed at that address. If you use a bootloader, the bootloader assumes that the application...
Friday, 29 April 2011 - 11:17
Implementing MikroC/OS in AVR32UC3B0256 (EVK1101 board)
I'm not familiar with uc/OS-II but what's in the first 2 bytes? The default reset vector is 0x80000000. Have you tried adding a single task? It might be easier to start of with...
Friday, 29 April 2011 - 09:26
NGW100 i2c problem
Can you find the function in i2c-dev.h? What are your compile options? What optimization settings are you using? Have you tried running the build with verbose enabled?
Friday, 29 April 2011 - 09:21
CDC Example: Enumeration Problem (Device task)
By EVKs I mean the Atmel dev boards; like EVK1104. If my memory serves me right; OSC0 is used to setup PLL1. The USB requires a 48 MHZ clock. Is the PLL1 multiplier set to 3...
Friday, 15 April 2011 - 07:40

Pages