Post Created date
[TUT] [C] Newbie's Guide to AVR Timers
This is the code I am using. When I run it, portb jsut stays low. Is it possible there are some fuse settings that would mess this up? #include #include int main (void...
Sunday, 26 August 2007 - 22:10
[TUT] [C] Newbie's Guide to AVR Timers
I don't know if this should go here, but I can't get the ctc code in part 4 to work on an atmega8. All the registers seem to be the same. Sorry if this is not the place to ask. -...
Wednesday, 15 August 2007 - 21:34
problem programming atmega64l using avrisp programmer
No the chip is not in a socket. I don't have a zif socket right now, so I'm just holding the chip down to the dragon. If thats a problem, I can wire the dragon to a socket on...
Wednesday, 8 August 2007 - 05:38
problem programming atmega64l using avrisp programmer
I have this problem too with the AVR Dragon. I wired it up to program in hvpp. I couldn't really figure out what the fix was from this thread. Any help woudl be appreciated. I...
Tuesday, 7 August 2007 - 18:24
AVR Programming Problem
I ended up wiring the dragon for parallel programming, and it works now. Thanks for all the help.
Thursday, 26 July 2007 - 20:50
AVR Programming Problem
to the best of my knowledge it is. The isp pins go to the correct pins on the dragon. The chip is powered from vcc from the dragon. All thats hooked up on the chip is the reset...
Thursday, 26 July 2007 - 03:42
AVR Programming Problem
100 hz. Trying to change it to something else produces an error saying setting sd=0x06 failed.
Thursday, 26 July 2007 - 03:22
AVR Programming Problem
It produced an error and says the signature is 0x00 0x00 0x00.
Thursday, 26 July 2007 - 02:46
AVR Programming Problem
I can set the frequency. How do I read the signature of the chip?
Wednesday, 25 July 2007 - 21:34
AVR Programming Problem
The vdd pin and pin 2 are tied together on the dragon. The dragon does not require a separate power supply apart from the usb does it? I will check to make sure about the build...
Wednesday, 25 July 2007 - 19:13
AVR Programming Problem
I have only the reset pullup resistor and the isp connections. The programmer is the avr dragon, which is usb and hopefully avr studio compatible. -Mason
Wednesday, 25 July 2007 - 12:55
AVR Programming Problem
I'm doing that. It still gives and error when I try to change fuse setting or do anything in avr studio. When I start it up at first, it can read the isp frequency fine, but after...
Wednesday, 25 July 2007 - 12:08

Pages