Type in the full discussion title or a part of it.
Discussion Title Created date
Timer value and pulse width produced.
  Hi All,   I am using ATmega1608(28 pin). I am trying to produce a pulse width in the range of 1us-20us using singleshot mode of Timer B. Singleshot mode works fine i.e...
Wednesday, 21 September 2022 - 16:59
Regarding a glitch pulse from TCB in singleshot mode
Hi all, I am using ATmega1608 and IAR for AVR IDE. I am trying to program Timer B in single-shot mode and this single-shot will give a pulse width of 1us-15us depending on the...
Wednesday, 14 September 2022 - 19:44
Event system in ATmega1608
Hi All,         I am trying to build a system which will require me to first initialize TCB1 as Event user for generating a single shot pulse...
Thursday, 25 August 2022 - 16:10
Reading voltage on a GPIO pin (non adc)
Hi All, I am using ATmega1608(28 pin). Is there any way, I can use a GPIO pin (PF0 on AVDD domain) as a voltage reader. I will get 3 different voltage on that pin 0V, 2.5V and 4....
Monday, 8 August 2022 - 21:47
Analog comparator in Atmega1608
Hi All, I am trying to use Internal Analog Comparator in ATmega1608 and have been facing some issues in configuring it. I am using PD2 as positive input pin and PD3 as Negative...
Friday, 5 August 2022 - 16:07
Trying to use TimeB in single shot mode
Hi All, I am trying to use TimerB of ATmega1608 in Single shot mode. The event to trigger this single shot mode comes from internal Analog comparator. I first initialized the...
Wednesday, 3 August 2022 - 20:09
Creating a single pulse in ATmega1608
Hi, I am trying program ATmgega1608 but have a question. I want to make a single 30us pulse on pin PA3, at the beginning of program and after that it should go back to low. I have...
Wednesday, 3 August 2022 - 15:55
Trying to initalize Event system on Atmega1608
Hi, I am trying to initialize Event system on ATmega1608, so that Analog comparator (AC0) is Event generator and TCB1 is event user. I am using IAR IDE. It gives me error when I...
Thursday, 28 July 2022 - 16:55
Reading EEPROM values in ATtiny806
Hi, I am using ATtiny806 for my project. I am storing the number of time a specific interrupt occur in EEPROM. Now, when I unplug the system for ex- after a year, I want to see...
Monday, 18 July 2022 - 19:30
MCP2200 (USB to UART bridge) understanding.
Hi, I am trying to send data to a Embedded USB host(HID) through a MCP2200, which is acting as a bridge and on the UART side I have a ATTiny806. I am attaching block diagram of...
Monday, 11 July 2022 - 21:54
Difference between adc enable and adc start conversion bit
I was reading ATmega1608 datasheet and inside ADC subtopic I found two bits first one is ENABLE in ctrla register and STCONV in command register. What is the difference in these...
Friday, 1 July 2022 - 03:13
Uploading UART bootlader on ATtiny806 and flashing
Hi, I am looking to upload a UART bootloader which is provided by microchip( AN2634 application note) on my ATtiny806. Currently I flash my Firmware using Atmel ICE and UPDI...
Wednesday, 29 June 2022 - 16:11

Pages