Post Created date
Getting started ATtiny 1 & 0 series / Application Notes
In short stay away form attiny-0 -1 chips until someone get the act together, the old tiny's works, and we are many in this forum that has used them for many years.
Wednesday, 27 February 2019 - 10:17
Getting started ATtiny 1 & 0 series / Application Notes
Well, the answer to your question is: They dont care. But why do they then care making app. notes then? (The info about a chip should be only one place)   I know Atmel was...
Wednesday, 27 February 2019 - 08:17
AVR works after pressing Reset Button
You have 24V 20A power why?   Perhaps there are some other "big" loads that make the ground jump. (I expect that 24V and 5V share ground).   Does the chips control some...
Tuesday, 26 February 2019 - 15:15
Solved: MEGA328PU-TH and cold - Junk in serial communication
ok first I assume that OP use full swing osc, (not low power that only should be used up to 16MHz).   Perhaps Microchip again try to produce mega328P on the same line as...
Tuesday, 26 February 2019 - 11:55
Getting started ATtiny 1 & 0 series / Application Notes
And the big question for me is why don't it get changed, when it's clear for the one that did the app-note know that the data sheet is wrong (or perhaps he knew that using TX...
Tuesday, 26 February 2019 - 10:23
Watchdog Timer on the 328p makes a GREAT temperature sensor!
I think that it's because "Arduino-land"  don't like hacks!    The problem is that things like this is hard to make modular, so many things can work together...
Monday, 25 February 2019 - 18:38
Watchdog Timer on the 328p makes a GREAT temperature sensor!
It's old news, somewhere here there is a thread for a tiny85, that do the same.   And in the real world I don't beleive 0.005 C !!! (or give me a way to make 5.0000V...
Monday, 25 February 2019 - 15:43
Simple 3D graphics on an AtMega microcontroller
first a 80286 needed a 80287 to have FP. (as I remember the 80486 DX was the first with buildin FP (there was a SX without)).   Which display do you use ? (some displays...
Monday, 25 February 2019 - 10:07
Solved: MEGA328PU-TH and cold - Junk in serial communication
None of the two "OP's" have told about which Voltage they run at, and like the graph on #11 show that matter when you use the speed out of the bag.   When you want 9600 Baud...
Thursday, 21 February 2019 - 23:39
[FAQ]: Call instruction simulation in Atmel Studio 7
This is the same as rcall can flip over on chips with more than 8K flash.   From the datasheets on AVR's with 8K flash it's clear that rcall can reach all the flash, but it's...
Wednesday, 20 February 2019 - 12:15
USART in MSPI mode as a fast shift register
I would not use sleep it's faster to jump to 30 nop's (or whatever is needed) then there will be no jitter on the ISR , and no extra clk to start from sleep.    
Tuesday, 19 February 2019 - 21:36
USART in MSPI mode as a fast shift register
I have to ask what else do you need to do? And which dot clk speed do you need ? (and AVR speed for that?).   And the line timing, number of visible lines and total...
Tuesday, 19 February 2019 - 09:12

Pages