Post Created date
Configuring Output pin to check output at MIXED SIGNAL OSCILLOSCOPE in ATMEL SAME70-XPLD BOARD
output of adc in form of digitized data. So that I can verify my analog signal is getting converted properly or not
Wednesday, 26 February 2020 - 08:20
SAME70 Xplained TCM example: Usage Fault at address 0x20003000 after Power On Reset
Hey there. I'm also working on SAME70-XPLD BOARD,the example code which they have given for tcm for sum of numbers from 1 to 100,in this code from where are they taking the input...
Tuesday, 18 February 2020 - 06:29
SAME70Q21 micro-sam-ba unable to write memory
Hey there.. I am working on atmel same70Q21 development board. I'm programming for adc ,storing the adc data into memory then dac. My adc part is working. I wanted to ask that how...
Wednesday, 12 February 2020 - 08:52
ATMEL ARM SAM E70 BOARD Memory configuration
Yes you are right TCM is mapped to internal SRAM. Moreover the memory stored in TCM is accessed by DMA, so I'll have to do coding for TCM or DMA?? in the example codes they have...
Wednesday, 12 February 2020 - 04:43
ATMEL ARM SAM E70 BOARD Memory configuration
Actually SAM E70 XPLAINED BOARD uses TCM which is mapped to SRAM. So I am confused that how to start programming the memory part in order to store the data from ADC. Also if...
Tuesday, 11 February 2020 - 04:46
Reading ADC channels in Same70 Xplained board
yes  https://de.farnell.com/atmel-sam-e70-explained-evaluations-kit  this board pls send working code for adc...
Thursday, 30 January 2020 - 15:29
Reading ADC channels in Same70 Xplained board
Hello Sir, I am working on the ATMEL SAM E70 BOARD FOR ADC. I'm facing problems in configuring the code. Could you please send the correctly working code for adc if u have any....
Thursday, 30 January 2020 - 06:00
AMTEL SAME70 AFEC CHANNEL 10
pls send me the working code for adc on  ATMEL SAM E70 board if u have worked...ITS URGENT....!
Thursday, 30 January 2020 - 05:38
ADC/AFEC in SAM E70, HELP!!!
Hey there,  I'm also working on the SAM E70 board for ADC. Could u pls send me your perfectly working adc code as for the below attached code I'm not getting desired output,...
Thursday, 30 January 2020 - 05:31
AMTEL SAME70 AFEC CHANNEL 10
ARM CORTEX M-7 SERIES (ATMEL SAM E70) BOARD
Thursday, 30 January 2020 - 05:10
AMTEL SAME70 AFEC CHANNEL 10
Hey there. I am also working on setting up ADC on SAM E70 board. could you please send me your working code, actually I'm getting 1111 at the output..its URGENT  
Wednesday, 29 January 2020 - 09:21