Post Created date
help with code changes for attiny10
Yes yes I built the project, and then I program it
Wednesday, 25 March 2020 - 17:06
help with code changes for attiny10
Nothing always changes as before   To understand if I'm wrong, you could tell me the sequence I do to program the attiny10 is right, - start AtmelStudio, - I open the project...
Wednesday, 25 March 2020 - 08:07
help with code changes for attiny10
I don't know if I did it right, maybe explain it better, but it gives me two warnings Warning        large integer implicitly truncated to unsigned...
Tuesday, 24 March 2020 - 19:06
help with code changes for attiny10
I measured with a multimeter and these are the values that the PWM gives me with each press of the button off = 0.04 1 = 4.29 2 = 4.74 3 = 4.70 off = 0.04 I think it should have...
Tuesday, 24 March 2020 - 17:52
help with code changes for attiny10
no it is not so pin 4 is a 5v output that must be connected to pin 2 if the pwm pilot is not used
Tuesday, 24 March 2020 - 17:26
help with code changes for attiny10
I put you the circuit diagram
Tuesday, 24 March 2020 - 16:56
help with code changes for attiny10
ka7ehk wrote: Perhaps Lidas has not yet grasped the relationship between timer register settings, PWM duty cycle, and motor speed? Maybe this will help. Or, maybe not!   To...
Tuesday, 24 March 2020 - 07:20
help with code changes for attiny10
Lidas wrote:then I opened this hoping to do the right thing You still need to go back and give a link to this thread - so people don't waste time in the old one because you didn't...
Monday, 23 March 2020 - 16:27
Attiny10 is not scheduled
Sorry I opened another more specific thread we continue the discussion there, thank you so far who will help me   https://www.avrfreaks.net/forum/help-code-changes-attiny10
Monday, 23 March 2020 - 16:24
Attiny10 is not scheduled
For me thanks to you I solved this problem, I could not program, the solution is that Attiny10 must be programmed at 5v Percciò declare this problem solved Thank you
Monday, 23 March 2020 - 15:52
help with code changes for attiny10
It is not true it is not the same thing, the other post I asked how to program and in the end I did it, so for me it was over, I also asked there but it seemed to make me confused...
Monday, 23 March 2020 - 15:49
Attiny10 is not scheduled
hi, no programming expert to help modify this firmware, please thank you
Sunday, 22 March 2020 - 13:14

Pages