Post Created date
attiny85 and sleep mode
Please Always say what you do and then link the result. Otherwise it is difficult to understand what is going on. Assuming that each press creates a short impuls, you have some...
Tuesday, 14 January 2020 - 06:34
attiny85 and sleep mode
Hmm. And I assume you pressed all the time constantly? Looks like a repetitive pulse with a bit varying frequency. Maybe depending on Speed, pressure and length of ...
Monday, 13 January 2020 - 21:59
attiny85 and sleep mode
Ah, you have a QUIMAT with DSO Shell. Good enough for measurements like this. Try again and again to push the button for more or less exactly two second with constant pressure (...
Monday, 13 January 2020 - 21:03
attiny85 and sleep mode
Maybe building a simple circuit of a battery, resistor, LED and button. If you press the button for 1 second, I would expect that the LED just lightens up for a short impuls at...
Monday, 13 January 2020 - 20:43
attiny85 and sleep mode
Yes, I would take out the resistor and work with the internal pull-up at PB2 by using PORTB = 0b00000100; //maybe 0b00000110; if still PB1 and PB2 are connectedYour wish for the...
Monday, 13 January 2020 - 19:45
attiny85 and sleep mode
Lidas, if (!) it will work and if you Change to PB2 then you could leave the Code like it is. But it would be cleaner to switch off the unused internal pull-up-resistor at...
Monday, 13 January 2020 - 13:51
attiny85 and sleep mode
Hi clawson, Cool, thanks a lot. Didn't know that and will use it from now on.
Monday, 13 January 2020 - 13:00
attiny85 and sleep mode
Can you confirm the following behaviour of the switch (by measurement with adequate Equipment)? If yes, I believe that your finger on the sensor is not giving a constant pressure...
Monday, 13 January 2020 - 11:08
attiny85 and sleep mode
Maybe using a piezo-button is not the best starter-Project ;-) A piezo-button is obviously creating everything but not a precise on/off-signal without further processing. I am a...
Monday, 13 January 2020 - 06:34
attiny85 and sleep mode
I am sorry but I never worked with a piezo-buttoon so far. I understand that the on-state is really short. Then consequently the above mentioned debouncing-method is not the right...
Saturday, 11 January 2020 - 20:09
attiny85 and sleep mode
Hey,   Good to hear that it works now. Congratulations.   Debouncing is a story for itself. I always use the "software"-debouncing which is simply implementing a delay...
Saturday, 11 January 2020 - 17:30
attiny85 and sleep mode
Hi Lidas,   I remember well that the sleep modus was confusing me as well for quite a while. I do not work with Arduino but directly with writing a c-code and use Atmel...
Thursday, 9 January 2020 - 20:01

Pages