Type in the full discussion title or a part of it.
Discussion Title Created date
CryptoAuthLib (TNG Lora) Support for SAMR34
I am a very new beginner to work with ATECC608A (TNG Lora), I have downloaded the CryptoAuthLib i found that HAL layer support was found only for SAMD21 but not for SAMR34. Can...
Thursday, 19 December 2019 - 12:37
ATtiny817 External Interrupt Generation
I am using PORTA PIN6 of ATtiny817 as input pin (source of external interrupt), I have a connected external momentary push button with external pull up resistor making it as...
Friday, 11 October 2019 - 13:45
Reading RTC Count register
Hi I am using a ATtiny817 xplained Mini , I am trying to read RTC CNT register but i could not see the value being updated? Adding to that should i disable the Overflow interrupt...
Friday, 11 October 2019 - 08:52
RTC Configuration
I am using a ATtiny817 xplained Mini, I want to toggle LED using overflow interrupt for every 10 sec from RTC, but i am not able generate the interrupt. Is the configurations...
Thursday, 10 October 2019 - 11:48
ATtiny817 Xplained Mini Clock Configuration
As the Title summarizes , I am trying to configure the clock source for the main clock through Low Power 32khz Oscillator, but even after that my main clock is...
Saturday, 28 September 2019 - 19:36
ATTiny 817 Qtouch Button Interrupt Generation
This title summarizes objective of the issue, I am trying out to generate a External interrupt using by pin state change (FALLING EDGE) using Q Touch Button but the interrupt is...
Saturday, 21 September 2019 - 09:21