Post Created date
XPLAINED 416 NANO board with ATtiny3216?
Hi Extronic,   Are you able to program with ATtiny416 Xplained Nano board apart from ATtiny416?
Thursday, 5 September 2019 - 04:14
Programming ATtiny412
ki0bk wrote: gkishore wrote: I am transmitting N bytes using I2C communication. To transmit 'N' bytes, If a delay of 1sec is given after transmitting each byte, the data...
Thursday, 29 August 2019 - 09:31
Programming ATtiny412
I am transmitting N bytes using I2C communication. To transmit 'N' bytes, If a delay of 1sec is given after transmitting each byte, the data transfer is proper....
Wednesday, 28 August 2019 - 05:44
Programming ATtiny412
With baud rate 4gkishore wrote: ki0bk wrote: Serial comms issues asked here usually relates to improper baud rate due to not knowing what the cpu clock rate really is set to....
Wednesday, 21 August 2019 - 11:46
Programming ATtiny412
El Tangas wrote: That's the problem of using Atmel Start without knowing what's happening. Please post the content of the clkctrl.c file, namely the CLKCTRL_init...
Wednesday, 21 August 2019 - 11:25
Programming ATtiny412
clawson wrote: Why are you using 250kHz as the clock speed in one place and 16MHz in another?   The idea would be that you define one system wide symbol somewhere (often on...
Wednesday, 21 August 2019 - 10:20
Programming ATtiny412
El Tangas wrote: Besides, all those numbers are irrelevant to the actual speed the chip is running, which is set by the OSCCFG fuse (which is a permanent setting at run time...
Wednesday, 21 August 2019 - 10:16
Programming ATtiny412
ki0bk wrote: Serial comms issues asked here usually relates to improper baud rate due to not knowing what the cpu clock rate really is set to. Where in your code above do you set...
Wednesday, 21 August 2019 - 04:19
Programming ATtiny412
Moe123 wrote: Wha do you want your application to do exactly, I just see that you are initializing the driver ? look at your code...what is your expectation out of this ? I am...
Tuesday, 20 August 2019 - 12:09
Programming ATtiny412
Now I am able to observe the log. But the displayed hex values are not as expected.   I am sending 0x12 but I am getting C9 C9.
Tuesday, 20 August 2019 - 11:49
Programming ATtiny412
Clock issue is resolved. Now I am able to use i2c for data transfer. New issue araised regarding serial communication.   I am using ATtiny416 Xnano board to program on board...
Tuesday, 20 August 2019 - 04:27
Programming ATtiny412
clawson wrote: gkishore wrote:And, where can I observe printf statements in atmel studio? You need to provide an output channel such as UART or LCD then you use FDEV_SETUP_STREAM...
Tuesday, 13 August 2019 - 10:12

Pages