Post Created date
I2C multiplexer device confusion
Okay Kuch thanks for all the information, appreciate it!
Thursday, 11 April 2019 - 13:03
I2C multiplexer device confusion
Yup so I will ground A0 A1 and A2. And since I will not read from MUX I will only use Write bit at the end in this case address will be 0b11100000. Well I will receive data tho,...
Thursday, 11 April 2019 - 05:32
I2C multiplexer device confusion
Thank you jpmargis :))) So if I my address matches with the A0,A1 and A2 pins multiplexer chooses the channel according to the transmitted data. And if address does not match to...
Wednesday, 10 April 2019 - 14:46
I2C multiplexer device confusion
Okay I believe I got the point, I will follow the same procedure I followed while I was trying to communicate with 1 battery without multiplexer. But.. again there are some...
Wednesday, 10 April 2019 - 14:26
I2C multiplexer device confusion
Thanks for the answers I still have some questions ( I am a newbie to all these stuff) In datasheet there is no address given for the multiplexer. Will it be a problem if I...
Wednesday, 10 April 2019 - 14:03
Weird signals on SDA/SCL pins for I2C
Yes, I just wanted to ask about the pull up resistors tho
Thursday, 4 April 2019 - 13:31
Weird signals on SDA/SCL pins for I2C
My bad, I am trying to communicate with a smart battery by using PIC, I want to get the state of charge information from it. SMBus v1.1 the battery uses
Thursday, 4 April 2019 - 13:21
Weird signals on SDA/SCL pins for I2C
  Actually in the datasheet of the device that I try to communicate it says this: (but I couldn't get what does it mean so I just used 20 k ohm )    
Thursday, 4 April 2019 - 12:57
RS485 to UART Convension
Thanks for the answers! Indeed very good explanation, appreciate it.
Saturday, 23 March 2019 - 09:08
RS485 to UART Convension
clawson wrote: GunkutA wrote: from one PIC to another PIC Can't help thinking you may have come to the wrong place??   Perhaps try:   https://www.microchip.com/forums...
Saturday, 23 March 2019 - 08:54
RS485 to UART Convension
Hello, yes unfortunately I am inexperienced. This one will be my first design. ( well it is simple one but anyhow.) I will send data from one PIC to another so my RS485 will be...
Friday, 22 March 2019 - 14:19