Type in the full discussion title or a part of it.
Discussion Title Created date
Force discharge circuit output high at low current consumption.
Hi all, I made an ATmega16 based stop watch and I want it to be power by a battery connected on of those charging, protection and boost modules. The problem is the circuit draws...
Monday, 22 February 2021 - 16:20
Multiplexing 7-segment LCD displays
Hi all, I know how to multiplex 7-segment displays, but does the same work for those LCD 7-segments? I attached an image of the display below.
Tuesday, 16 February 2021 - 09:27
How much distance can dc signal travel in cat6 cable?
I am using atmega32 to control two dc motors,my question is what is the max distance of cat6 cable that I can go with between the controller and the motor driver.I just want to...
Thursday, 23 May 2019 - 18:05
Syncronization of two or more separate atmega32
I want to design and implement 4 clock system for a swimming pool. I already made a single clock using atmega32's 16 bit timer and 7-segment for display, but my concern is when...
Tuesday, 21 May 2019 - 11:38
Atmega32 VCC and GND pins shorted
I accidentally connected power to atmega32 reversed(VCC to ground and GND to 5v) after that the chip didn't work correctly any more , I noticed that ground and vcc pins of...
Thursday, 14 February 2019 - 20:39
Atmega32 timming
I built a 4 digit clock that counts minutes and seconds using atmega32 and large 5 inch 7-segment display and it is working fine. My problem is that it is not that accurate, for...
Friday, 8 February 2019 - 21:17
Driving 5 inch 7-segment display
I'am trying to make a timer using 5 inch common anode 7-segments and atmega16 microcontroller, I already now that it needs around 15v to work. I got it working with smaller 7-...
Monday, 28 January 2019 - 21:14