Post Created date
EEPROM with attiny814
Hello , I tried using atmel start non-volatile basic file. It had .C and .H file and using the same functions i could write a value to its EEPROM address but the value is not...
Thursday, 14 February 2019 - 05:44
EEPROM with attiny814
Thank you for such a response. I am a amateur in embedded coding but have tried few projects with attiny402 and have started with attiny814. For my last thread i was able to use...
Thursday, 14 February 2019 - 04:58
I2C With Attiny402
My basic question was for clock but as you reply suggested to use atmel start, that issue got resolved but as the thread is in respect to I2C and the problems in regards to I2C...
Thursday, 20 December 2018 - 12:22
I2C With Attiny402
My slave is an DRV10983 BLDC controller IC. I have previously implemented I2C using a DSPIC to drive this IC and it worked properly using address of slave (0xA4) and data bytes. I...
Thursday, 20 December 2018 - 12:19
I2C With Attiny402
Correct, as there are commands for USART and SPI for choosing the alternative pins but for I2C these information is not given. Are there any other alternative way or I2C can't be...
Thursday, 20 December 2018 - 11:28
I2C With Attiny402
Hello David, I tried your replaced code but the results are same. Results: SDA and SCL are constant high  So i guess the master is not enabled properly or the pins are not...
Thursday, 20 December 2018 - 11:23
I2C With Attiny402
Hello David, Thank you for your constant replies to this thread it means alot. I am from India, and i have chosen attiny402 because i need to perform only single task of sending...
Thursday, 20 December 2018 - 10:59
I2C With Attiny402
Hey friend, I am just trying to find out the why I2C is not working in attiny402. I have used USART which are in the same pins as of I2C and they are performing appropriately....
Thursday, 20 December 2018 - 10:45
I2C With Attiny402
Hey David i have doe few changes in the code and using atmel start and atmel studio i am able to configure the system clock. But i am still facing issue with I2C the DATA line and...
Thursday, 20 December 2018 - 07:14
I2C With Attiny402
Hey David i tried changing the init function but the result is same the registers under CCP are not changing. Attaching the screenshot of the debug mode when i actually pause my...
Thursday, 20 December 2018 - 05:02
I2C With Attiny402
It is a xmega header file can we use it for ATTiny controllers. I tried using atiny402 header file but still there was a error.
Wednesday, 19 December 2018 - 06:15
I2C With Attiny402
Can you recommend a good tutorial for CCP registers?
Wednesday, 19 December 2018 - 06:14

Pages