Post Created date
Xmega ADC
dadams8355 wrote: What does the following statement do?   PORTA.PIN0CTRL = PORT_ISC_INPUT_DISABLE_gc;   Maybe its a good idea if you take a look at this application...
Friday, 18 October 2019 - 15:32
Atmega32 reset pin proper connection
This is the recommended RST circuit for AVR 8bit:       Am I missing something ? is this the right ATMEGA32 ? I dont see pin 10/Vcc + 11/GND ? did you draw this...
Friday, 18 October 2019 - 07:06
Atmega3209 Power down mode
Very happy you fixed your problem, one last thing, maybe in the next design its better if you take a look at your PCB.   - Decoupling caps, are a little bit far from the mcu...
Thursday, 17 October 2019 - 11:29
Atmega3209 Power down mode
Well, I would start with analyzing your PCB circuit concept...look for your HW, start removing part by part parallel to testing it
Thursday, 17 October 2019 - 09:21
Atmega3209 Power down mode
kabasan wrote: Remember to remove the debugger when measuring current consumption. The current flowing into the UPDI VTG is not small. +1  
Thursday, 17 October 2019 - 08:57
Atmega3209 Power down mode
If you dont mind guys, I will link this to my thread about getting started with 0&1 series...
Thursday, 17 October 2019 - 08:41
Atmega3209 Power down mode
Cliff, Could this make sense ?  3.6V@ 25 C the power consumption is less that 1uA ?!. how is this possible...
Tuesday, 15 October 2019 - 14:14
Atmega3209 Power down mode
well I would not measure it with a multimeter, I suppose you are also making the average calculation and so on, but this is not accurate. "best" way is to use an osci with a...
Tuesday, 15 October 2019 - 07:51
Atmega3209 Power down mode
Ok, so one question...sounds stupid....but how are you measuring your power consumption ? what is your setup to measure it ?
Tuesday, 15 October 2019 - 07:43
Atmega3209 Power down mode
Klemko wrote: I am running at 5MHz since you commented about wake rutine being faster. I left project running over night and it did have 4% lower total power consumption then when...
Tuesday, 15 October 2019 - 07:23
Atmega3209 Power down mode
Klemko wrote: In clock_config.h   /* Auto-generated config file clock_config.h */ #ifndef CLOCK_CONFIG_H #define CLOCK_CONFIG_H // <<< Use Configuration Wizard in...
Tuesday, 15 October 2019 - 07:13
Atmega3209 Power down mode
Klemko wrote:     #include <atmel_start.h> #include <util/delay.h> #include <funkcije.h> #include <avr/sleep.h> #include <avr/interrupt.h...
Tuesday, 15 October 2019 - 06:51

Pages