Type in the full discussion title or a part of it.
Discussion Title Created date
Where is the pinout summary??
Hello. Every microprocessor I have ever used, in the first few pages of the DS, there is a chart showing all the pins down one side, then all their functions in the chart. There...
Thursday, 15 August 2019 - 20:36
Capture on TCD0 with ATTiny
Hello.   I am using ATTiny816. I am attempting to capture a square wave and determine its timing. The signal is on pin PA5. It is usually 50% duty so I can capture the high...
Wednesday, 17 July 2019 - 02:31
How deep is stack on ATTiny -1 series?
Regarding device ATTiny416.   There is some discussion in the DS about how addresses are pushed and popped from the stack, but doesn't specifically say how deep it is that I...
Thursday, 5 July 2018 - 18:45
USART running at half expected speed?
Hello all. I'm using Attiny416.   I had UART working fine at 9600 baud, 20Mhz internal clock. To reduce current consumption I'm going to 10Mhz by turning on the...
Tuesday, 3 July 2018 - 20:53
How to send Watchdog Reset WDR?
Hello all. Sorry for all the noob questions, but I'm finding these AVR parts / Atmel Studio toolchain to be the most poorly documented MCU I've ever used. I've spent over an...
Saturday, 30 June 2018 - 02:57
Enabling BOD fuse?
This seems like an obvious question but the search function in the form returns far too many results - I can't figure out how to simple search a topic without the function...
Saturday, 30 June 2018 - 01:34
Stop tracking individual mEDBG devices?
I'm using AtmelStudio 7 with a bunch of Xplained Nano dev modules. Each module has embodied an mEDGB debugger.   Is there a way to make AtmelStudio stop tracking them...
Wednesday, 27 June 2018 - 22:33
mEDBG Serial fail
Hello all. I've been trying to get started with an ATTiny416 eval module (it is the Xplained Nano board). It has been total frustration, not finding anything useful for getting...
Thursday, 21 June 2018 - 23:43
Solved: Getting Started. Frustration. target 'main.o' failed.
Hello all. I've been at this for a few hours now, sorry for the noob post. I have decent experience writing C for PIC micros in MPLAB and I have a ton of Arduino experience, but...
Wednesday, 20 June 2018 - 22:58