Discussion Title | Created date |
---|---|
SAMD51 protection diodes Hi, does anybody know if the SAMD51 have two internal protection diodes on each push pull pin ? The datasheet gives no Information about that but some people say that... |
Tuesday, 15 January 2019 - 10:08 |
SAMD51 DAC Problem Hi, i have some trouble with my DACs. After the initial config and enabling i start the conversion by writing the desired value in the DATA registers. When i am setting a... |
Wednesday, 9 January 2019 - 06:11 |
UART starts automatic transmitting after enable Hi, i have a Problem with my UART on the SAMD51. After doing the initial config i enable the UART by set the enable bit. After that the UART starts transmitting... |
Friday, 21 December 2018 - 12:43 |
SAMD51 Digital Analog Converter Trouble Hi, i have some trouble with the DAC. I drive the DAC with an 8 MHz Clock, generated by a GCLK. Peripherial Bus enabled. The Output Pins are configured peripherial... |
Thursday, 20 December 2018 - 14:44 |
SAMD51 Trouble "Routing the OSCULP32K Osc. to a pin" Hi, i want to route the internal 32 kHz oscillator for measurement to the pin PB16. For that i configured the GCLK2 so that the OSCULP32 goes in and out without prescaler... |
Tuesday, 18 December 2018 - 13:41 |
Clock the AME54 with DFLL48M Hi, i want to use the internal DFLL48M oscillator for cpu clock. I know that makes no sense but i want to test something out the ATMEL Start gives me the warning.... |
Monday, 3 December 2018 - 18:44 |
ADSAD51N20 SWD Interface question Hello, i have some trouble with the layout of SWD interface. In my opinion the datasheet contradicts itself. So it recommend a 1 k pullup resistor for the... |
Thursday, 22 November 2018 - 07:56 |
USB connector wiring for SAMD51 Hello, i am looking forward to use a 5 pin USB 2.0 connector on my board. I doesnt know exactly how to do the physical part. There are examples which deals with and... |
Wednesday, 21 November 2018 - 07:21 |
How to select the desired SERCOM IOSET Hello, i am looking forward to implement the USART but have some trouble. I decide to use PC16 and PC17 for USART RX/TX. That would be SERCOM0 with IOSET4. The... |
Tuesday, 20 November 2018 - 16:46 |