Post Created date
In-system programming
Thanks Cliff. If the STK500 can program in serial high voltage mode (which I've done with tiny11s), then it sure seems like you must be able to pull the signals off the board. I...
Saturday, 11 November 2006 - 19:33
RstDisable Fuse
Thanks. My problem is in doing high voltage ISP programming onto my target system (which has an SOIC tiny13 soldered down--it cannot be removed and placed into a socket on the...
Saturday, 11 November 2006 - 19:30
In-system programming
Thanks Cliff. Since my application requires the use of the PB5, I can't iteratively program the part/debug/ re-program until the development is complete, THEN program the fuse....
Saturday, 11 November 2006 - 17:10
In-system programming
I finally got my card in and successfully programmed using ISP, and after all the detail that you sent, I screwed up and used the rst/PB5 pin in my design as PB5. Therefore I...
Saturday, 11 November 2006 - 16:24
RstDisable Fuse
I wish it was that easy. My part is a surface mount part. I normally use a DIP so I can go back and forth between plugging it into the STK-500 board for programming and my...
Saturday, 11 November 2006 - 15:39
[DIS] [ASM] Dirty Math Tricks: Adventures in Division by Ten
I tried running your 8 bit division code: Quote:;*************************************************************************** ;* "div8u" - 8/8 Bit Unsigned Division ;* ;* This...
Saturday, 21 October 2006 - 15:26
In-system programming
Great thanks a lot for your help. I should be all set. John
Thursday, 12 October 2006 - 22:43
In-system programming
Okay thanks. I think I understand. One more thing. It's not completely clear in the STK500 user guide, but it sounds like I can program my system with what comes in this kit...
Thursday, 12 October 2006 - 19:53
In-system programming
Thanks a lot for your reply. So I guess I will buy the AVRISP2 device since it will allow me to solder down the processor and re-program until it works like I need it to. I...
Thursday, 12 October 2006 - 19:01