Post Created date
facing a problem Nested if else in atmega 168p
Dear Mr N.Winterbottom, I wrote a code considering your advise (state machine). But it is not working. Maybe I missed something or library. Also, I considered timer flag...
Friday, 18 January 2019 - 10:11
facing a problem Nested if else in atmega 168p
I also tested Proteus. My hardware is working. First case executed. It skips sometimes case0 and case1. When I give case1 condition, it is not returning case 0 sometimes. It is...
Sunday, 13 January 2019 - 13:03
facing a problem Nested if else in atmega 168p
I uploaded code to my hardware.
Sunday, 13 January 2019 - 12:26
facing a problem Nested if else in atmega 168p
Thank you for your advise, I am trying to solve this problem.  I wrote some code. It seems to to work but it works sometimes incorrectly. It starts from case 2.  I...
Sunday, 13 January 2019 - 11:50
facing a problem Nested if else in atmega 168p
How to declare static variable?
Tuesday, 8 January 2019 - 19:25
How to operate working voltage Atmega 168PA ?
Yes, I used lithium ion battery.
Wednesday, 5 December 2018 - 21:42
How to operate working voltage Atmega 168PA ?
https://www.winsen-sensor.com/products/flat-surfaced-gas-sensor/mp-4.html
Wednesday, 5 December 2018 - 19:54
How to operate working voltage Atmega 168PA ?
Gas sensor works for 5 voltage. If voltage is less than 5 voltage, anolog is going up without sensing gas. So, I must avoid this issue.
Wednesday, 5 December 2018 - 19:14
How to operate working voltage Atmega 168PA ?
Yes exactly, I am looking for simple way without using ADC to read the Vcc voltage like brown out detection.
Wednesday, 5 December 2018 - 17:38
How to operate working voltage Atmega 168PA ?
If nominal Vcc level drops 4.9Volt, mcu should be off. Is it possible to do it?
Wednesday, 5 December 2018 - 14:52
Atmega 168pa MCU is not working properly sometimes
I considered before it averaging (sensors value/100). Could you lead digital filter in software?
Sunday, 2 December 2018 - 11:44
Atmega 168pa MCU is not working properly sometimes
I used LM324 op amp for analog signal(10kohm and 47uF). I used two 1000uF 25V 1000uf 10V for converting voltage. I am sure that hardware filter is OK. I didn't solder 0.01uF for...
Sunday, 2 December 2018 - 08:05

Pages