Post Created date
Total beginner, change state of outputrs in this code? (Resolved, thanks)
grohote wrote: jgmdesign wrote: I only saw one file in your ZIP upload so I do not know what GROHOTE is upset about     Sorry, one of "those" days... apologies for "252...
Wednesday, 24 November 2021 - 21:07
Total beginner, change state of outputrs in this code? (Resolved, thanks)
I'm back again, please forgive the noise :) If I power off the Arduino Uno (currently powered via its USB port to my PC) by unplugging the USB cable, when I power it on again by...
Wednesday, 24 November 2021 - 21:02
Total beginner, change state of outputrs in this code? (Resolved, thanks)
ki0bk wrote: MrBasil wrote: but now all relay buttons show ON   Restore the original code for the second part.... you just needed to change the state of the relays, not how...
Wednesday, 24 November 2021 - 20:26
Total beginner, change state of outputrs in this code? (Resolved, thanks)
jgmdesign wrote: in the INO file, change this: <SNIP>     UNTESTED, but should do the trick   JIm   Thanks a lot Jim, I loaded it but now all relay...
Wednesday, 24 November 2021 - 19:51
Total beginner, change state of outputrs in this code? (Resolved, thanks)
grohote wrote: Thee are 252 files there, can you reduce the number, please!   I apologise, but I am not sure what you mean, I just zipped up the whole .ino file, is that not...
Wednesday, 24 November 2021 - 19:49
AVR Dudess locks up Windows 7 64 bit PC
That made a big difference, thanks very much David!!
Friday, 28 June 2019 - 17:31
AVR Dudess locks up Windows 7 64 bit PC
The Atmega 328 is not in the U3S it's on a separate programming board with a ZIF socket. I have now managed to get AVRDudess to read a programmed chip and write a new one, but I...
Thursday, 27 June 2019 - 17:31
Newbie programming board jumper question
Brian Fairchild wrote:MrBasil wrote: Thanks for the replies, here is a link to the instructions and they contain photos and a schematic:   http://rocket.payload.free.fr/Do...
Friday, 2 February 2018 - 19:19
Newbie programming board jumper question
Thanks for the replies, here is a link to the instructions and they contain photos and a schematic:   http://rocket.payload.free.fr/Do...
Thursday, 1 February 2018 - 07:00
Xtal frequency for standalone programmer board question
Thanks for the further info DocJC, much appreciated!
Tuesday, 16 January 2018 - 13:02
Xtal frequency for standalone programmer board question
Is that `cos it's a 16MHz clock on this board? Or something else Jim? Thanks.
Monday, 15 January 2018 - 17:22
Xtal frequency for standalone programmer board question
Thanks Jim. I normally programme my own from the serial port socket on the back, but I have had a few requests to do chips from blanks for people, and I didn't want to be...
Monday, 15 January 2018 - 17:00

Pages