Post Created date
Atmel Studio 7 and sprintf
Have you included the stdio and stdlib headers?   #include <stdio.h> #include <stdlib.h>
Wednesday, 8 July 2020 - 16:15
Run ATSAMD51G18A with 120 MHz internally clocked?
You can use Atmel Start to configure the clock settings. You want to use the 32.768k internal oscillator as an input of GCG3 and than rout that into the DPLL0 then rout that to...
Wednesday, 15 April 2020 - 19:36
AS7 Version 7.0.2397 Error on Windows
Have you tried running Atmel Studio with administrator privileges?
Thursday, 6 February 2020 - 14:30
SAME5 @ 120MHz - Dumb Crystal Question
Yes 24MHz XTAL will work fine! Just go through the Atmel START clock configurator... Make sure to also set up the NVM wait states in the CPU section.
Saturday, 25 January 2020 - 17:33
ATMEL-ICE to ATSAM MCU through PCB header - SWD interface - Pinout confirmation
if unsure, you can put a 0 Ohm resistor in between the pin and ground, just not fit it if not needed. I always follow the pinout on the schematic checklist in the datasheet, never...
Thursday, 16 January 2020 - 12:16
ATMEL-ICE to ATSAM MCU through PCB header - SWD interface - Pinout confirmation
Check the Schematic Checklist chapter of the datasheet. http://ww1.microchip.com/downloa... Chapter 58, Page 2127
Sunday, 12 January 2020 - 19:24
SAME54P20 Bootloader/Self Programming features?
It's best to modify a working bootloader and add support for I2C or Ethernet to that. I use uf2-samdx1 bootloader by Microsoft, that has USB Mass Storage and UART support built in...
Friday, 10 January 2020 - 13:40
USB CDC Echo Using SAMD21-Send different data from another function.
You have to   int main(void) {     atmel_start_init();   //cdcd_acm_example();     char str[12];   sprintf(str, "HELLO WORLD\n");  ...
Sunday, 8 September 2019 - 15:41
how to implement USB device Vbus change event in ASF4 START?
Does your application have a power source other than USB? If so you have to make sure that it can not feed power to the USB port (with a diode for example).  Self-Powered USB...
Saturday, 10 August 2019 - 09:02
How to transfer by DMA results reading more then one ADC PIN?
Take a look at the "ADC DMA Sequencing Example" in Atmel START. It is for the E54 Xplained Pro, but should work similarly for your target device...
Saturday, 10 August 2019 - 08:40
How do I get 120MHz cpu speed using crystal on the ATSAMD51
Even if you don't want to use Atmel Studio, Atmel START gives you a nice interface to configure the clock sources, PLLs etc. You generate the project and upload it to your board...
Saturday, 10 August 2019 - 08:27
ASF XMEGA [DMA => DAC] Continous transfer? No manual retrigger!
I'm not sure how I could set repeats to infinite?!
Sunday, 29 April 2018 - 17:50

Pages