Post Created date
Mega64 Pins 23,27,28 out only 2.5 volts
My apologies, I will make sure it won't happen again. Thank you for the heads-up.
Thursday, 30 November 2017 - 15:48
Mega64 Pins 23,27,28 out only 2.5 volts
My apologies, I am quite new to this community and I am trying to learn from my mistakes. I will make sure not to do the same mistake again. Thanks for your suggestion.
Thursday, 30 November 2017 - 15:47
Mega64 Pins 23,27,28 out only 2.5 volts
I tried to include the m103 compatibility based on a suggestion by another member of the group for my previous post, my m64 and FTDI weren't performing serial communication due to...
Thursday, 30 November 2017 - 15:45
Mega64 Pins 23,27,28 out only 2.5 volts
Well, I was looking for posts which are close to my problem, I am posting on other threads too which are closely relevant. Thanks for your response. 
Wednesday, 29 November 2017 - 22:46
FTDI module's leds blink, but no data is sent/received
I am using an FT232R breakout board (https://www.digikey.com/product-...) I have tried to connect Tx-Rx and read data, everything on FT232R side is working fine....
Monday, 20 November 2017 - 22:07
FTDI module's leds blink, but no data is sent/received
I am using an FT232R breakout board (https://www.digikey.com/product-...) I have tried to connect Tx-Rx and read data, everything on FT232R side is working fine.   TEST...
Monday, 20 November 2017 - 22:06
FTDI module's leds blink, but no data is sent/received
I suppose I grounded it, I will try to recheck it and as suggested by other members, I will redo the circuitry neatly and separately from my other circuit blocks. I will reverify...
Saturday, 18 November 2017 - 16:21
FTDI module's leds blink, but no data is sent/received
I suppose the default fuse setting was lfuse 0x67 I guess(I have to check once I go back on Monday), with that, it used the internal 8MHz oscillator, with 0xFF lfuse M64 uses...
Saturday, 18 November 2017 - 16:17
FTDI module's leds blink, but no data is sent/received
I did try doing that, linking Rx to TX and it works pretty well. There must be some other issue on the MCU side only, which I am trying to rectify based on above responses.  
Saturday, 18 November 2017 - 16:12
FTDI module's leds blink, but no data is sent/received
Hello,   Thank you for your quick response. Yes, I have 16MHz xtal for my M64 fuse setting is 0xFF for lfuse, hfuse unchanged (based on the online calculator) Yes, my...
Friday, 17 November 2017 - 22:10
FTDI module's leds blink, but no data is sent/received
Hello,    I have been facing a similar issue. It took a while to figure out and update my FTDI. I uploaded a serial transmission code to my ATmega64, before that I even...
Friday, 17 November 2017 - 21:30
Device Signature 0x000
I did try to use pin 2 and 3 but I messed up some other connection at that time, later on, my overlooked that option and eventually fell into the same trap as u said. Thank you,...
Wednesday, 8 November 2017 - 15:36

Pages