Post Created date
jtag'ing
actually you dont need much to read a "sd" card. your talking after all two serial busses. I'm looking at one design that has 8 avr32 on one board, so getting rid of 7-8 parallel...
Tuesday, 26 June 2007 - 03:18
jtag'ing
There are linux jtag tools. Actually one of the "Interesting" things I was thing of, was using a "avr" 8 bitter as a "boot" controller for the AVR32. Since the "normal" boot is...
Tuesday, 19 June 2007 - 04:26
avr32 python
2.2.1 is really old. How about 2.5?
Tuesday, 19 June 2007 - 04:16
Connecting an USB host chip
Yes, I have connected up the DMA. Also wifi bandwidth on the typically usb dongle is not "all" that much, and even reading and writing a hard drive can be quite fast. Depending on...
Friday, 18 May 2007 - 03:46
AVR32AP7000 and DVI screens
Yes, if you use the right DVI serilizer you could hook up a DVI. The avr32 does not really care that much. At most you need a little i2c setup for the dvi chip. Already looked at...
Tuesday, 24 April 2007 - 09:40
Startup time
Also, you can do a "reverse". You let linux boot up to a point where everything is "ready" then go into low power mode. So when the user "powers-off" you "reboot", and pause in...
Thursday, 12 April 2007 - 23:46
Ideal board - any one building this?
I'm doing it. I have the max supported SD-RAM, and a 44pin IDE, as well as 9 USB ports. I've switched to MicroSD as well. If you look at my other posts, full specs are there. I'm...
Thursday, 12 April 2007 - 11:03
Connecting an USB host chip
actully got the driver in source, I'll get it up and running. Its a important part of my board. Once it finished, i'll post it, so you dont have to worry about it. Also the board...
Monday, 9 April 2007 - 16:37
STK1000 / AVR32 Camera support ?
actually i'll make it even easier for you. How about a avr32, micro-sd, usb-2 device, and a kodak 5 megapixel sensor ready to plus in and use. :) Comes up as a "ehternet" device,...
Friday, 6 April 2007 - 15:41
Connecting an USB host chip
EBI bus, and its a Phillips ISP1760. Its designed for embedded.
Friday, 6 April 2007 - 15:27
IDE support
I have to go back and look at that page. I believe its a TI part number. I replaced the CF slot, with a 44 pin ide. Since my board has 9 usb host ports, cf is somewhat redundant.
Friday, 6 April 2007 - 15:21
Connecting an USB host chip
I finished interfacing a phillips USB 2.0 host, plus I've included a USB HUB as well. So my boards got 9 ports. It also has ATA/IDE (44 pin connector).
Tuesday, 3 April 2007 - 14:12

Pages