Post Created date
Looking for SSD0323 OLED controller sheet
Hi theusch Thank you for the link, i entered my data there but unfortunatly I got no answer till today. Cheers Michael
Friday, 21 December 2007 - 09:52
Looking for SSD0323 OLED controller sheet
Could you please also mail me the datasheet.Last week I got my hands on two univision oled deisplays. The are dropins for the osram calgary. rubitschka at hotmail dot com Cheers...
Tuesday, 18 December 2007 - 15:00
[TUT] [HARD] [SOFT] How to build a Nixie Clock
Hi Peret Thank you verry much for this brilliant article! I recently built a dekatron clock and had a problem with the hv coil, the cory wasn't powerfull enough. Altough...
Monday, 20 November 2006 - 14:40
questions about Timer1 of ATmega8
Why not filter the pwm with an rc link. So you could measure the channels with the builtin adc. Cheers
Monday, 18 July 2005 - 08:32
1.5 ms 50 Hz PWM on ATmega8535
bobgardner wrote:The easiest way to set up all those pesky registers is with the 'application builder' someone wrote. I think there is a link to it here somewhere... it comes with...
Monday, 18 July 2005 - 08:29
Problems with PWM
Sorry Shame on me, I pasted the wrong code,... This was the code with the 122Hz, interestingly then I tried the code above, phase correct 9Bit pwm, but the frequency was the same...
Thursday, 30 June 2005 - 10:56
Measuring duty cycle from pwm
Dear Armin Thanks alot , I will try this out today! Cheers Michael
Wednesday, 22 June 2005 - 13:58
Driving Sharp LQ121S1DG11 Colour LCD
There are some circouts around for an EPSON lcd controller. Unfortunatly I cant find them anymore and I dont know if the controller is sufficial for this amount of data. I think...
Wednesday, 22 June 2005 - 13:32
Measuring duty cycle from pwm
I would prefer the ADC, because i am using the ICP1 already,... What values would you suggest for the R and the C ? The frequency of the pwm is around 1kHz. Cheers Rubi
Wednesday, 22 June 2005 - 13:28
UART library for atmega162?
Hi I solved the problem and must admit this was a stupid fault. I thought since I could programm the hex file with my AN910 progger, it is also possible to set the fuses with this...
Wednesday, 8 June 2005 - 09:51
fuse bits for ATMEGA162 to use 7.3728 Mhz crystal oscillator
Hi I solved the problem and must admit this was a stupid fault. I thought since I could programm the hex file with my AN910 progger, it is also possible to set the fuses with this...
Wednesday, 8 June 2005 - 09:50
fuse bits for ATMEGA162 to use 7.3728 Mhz crystal oscillator
theusch wrote:I do not think that the crystal >>will<< oscillate until you set the fuses to correctly use the installed crystal. Also, when setting the fuses, remember that...
Tuesday, 7 June 2005 - 13:49

Pages