Type in the full discussion title or a part of it.
Discussion Title Created date
Studio5 and simulation vith codevision && install st
Hi, I have a new PC with WIN7 64bit. try to install avrstudio5 and run codevision. I can not find how to load *.cof file to start simulation? What are you missing? Try after that...
Tuesday, 19 April 2011 - 13:28
Use Reset as pin & ISP programering.
Hi. For me when you use Reset as Input you can not program the chip with the ISP interface. I will use a Tiny4313 and need one more input but I do not want lose ISP programering (...
Wednesday, 30 March 2011 - 16:47
Batch prog with STK500 and read signature bits
Hi guys. It is possbile to read the signature bytes and use the information in a batch file. you can read with: stk500 -ATTINY24 -s on the screen you see the answer and the "...
Wednesday, 9 March 2011 - 12:08
What does / means " if( !Read_Temperature_DS18S20()==TR
Hi. What means the " ! " before the routine. I try to convert a AVR program from IAR to codevision. I have finish and not error. but do not understand the "!" before the call...
Saturday, 28 August 2010 - 06:28
low pass filter
I have read on one AVR forum an explication for digital low digital pass filter. But I do not find again. Can someone give me the link? Thierry
Monday, 14 December 2009 - 08:58
Tiny45 & power use for timer1 it is rigth value in the d
Hi. I am design a board with a tiny45 som will be power through a 330nF X2 275 + zener +++ This power will not give more than 7mA when Mainvoltage is low 230V -20%. No problem....
Tuesday, 24 November 2009 - 14:23
AVR476: Touch Remote Control
Do you have see this application note? Can we use a standard avr for touch sensing? Thierry
Friday, 4 September 2009 - 06:01
XPORT lantronix + ATMEG164P
Hi. CPU atmega164P Codevision just a question. I run the ATmega164P to 18,432MHz. Uart is set to 9600baud. If I send char (with "putchar") I need to use a delay between 2 char. It...
Thursday, 4 June 2009 - 16:18
Signatur byte = 0xFF ++++
OK. I get a board form field after 2 years working good. I read the signature to 0xFF+++ and I this at all memory is to 0xFF. I will try to see if the MISO is not died to explain...
Friday, 20 March 2009 - 07:50
Modbus timing!
Hi guys.. I see a lot information about modbus & avr but can someone make a clear drawing of timing. I try to understand but no get all. Mode RTU and send data from uart is...
Thursday, 26 February 2009 - 13:25
STK500 via Linux
Hi. I am not a guru with linux perhaps my question is stupid. It is possible to run STK 500 via Linux like commande line bath file? Why: it is possible to by small pc with linux...
Friday, 13 February 2009 - 15:03
Transistor with special connection
Hi. I want to detect at a switch used to turn on / off See the schema to understand. My question: The base of T1 see 30V & Emitter 5V. If you see the data sheet it is not good...
Thursday, 8 January 2009 - 11:59

Pages