Post Created date
register macros used in smiley book not in avr-libc?
thanks guys!
Sunday, 7 May 2006 - 06:39
[DIS] [BUTFLY] Solution to the Butterfly 0x940c error
also note: rather than unplugging your parallel cable each time you want to switch your avr from flash mode to run mode, you can instead simply disconnect pin 5 of ISP (the reset...
Sunday, 7 May 2006 - 04:27
[TUT] [C] Bit manipulation (AKA "Programming 101")
this is also touched on in "AVR035: Efficient C Coding for AVR" http://www.atmel.com/dyn/resources/prod_documents/doc1497.pdf I based a few macros off of that app note, and...
Thursday, 4 May 2006 - 21:58
[DIS] [BUTFLY] Solution to the Butterfly 0x940c error
also, you may need to (as I did) create your parport device nodes before you can use them. from http://www.ussg.iu.edu/hypermail/linux/kernel/9907.2/0139.html: mknod /dev/...
Thursday, 4 May 2006 - 21:50
[DIS] [BUTFLY] Solution to the Butterfly 0x940c error
I put up an album of photos with a little bit more detail for the rest of you who may encounter this problem. http://jason.pepas.com/photos/bsd-flash here are the pin connections...
Thursday, 4 May 2006 - 08:25
[DIS] [BUTFLY] Solution to the Butterfly 0x940c error
SUCCESS!!! Ok, I also had some 150 Ohm resistors lying around, so I tried those instead, and it worked! # avrdude -p m169 -c bsd -P /dev/parport00 -U flash:w:/tmp/blinky2.hex...
Thursday, 4 May 2006 - 07:56
[DIS] [BUTFLY] Solution to the Butterfly 0x940c error
ok, I hacked together the 'bsd' programming cable as described here: http://www.bsdhome.com/avrdude/ here is what it looks like: However, I only had 2.2KOhm resistors on hand,...
Thursday, 4 May 2006 - 07:48
[DIS] [BUTFLY] Solution to the Butterfly 0x940c error
Hi guys, another 0x940c problem here. I constructed the parallel cable described at http://bluebat.dnsalias.org/howto/butterfly/ I then added the entry to avrdude.conf:...
Wednesday, 3 May 2006 - 04:54