Post Created date
USART Interrupt
Steve, thanks. I am going to read the tutorial and if i have any doubts I will came back Regards, Manuel
Thursday, 23 December 2010 - 00:57
AVRStudio Simulator and AVR C library
Hi, all! Thanks Again for your suggestions and advise. Based in your comments I plan do my project this way: One of the my hobbies is aeromodelism. My project is to make an...
Tuesday, 3 August 2010 - 12:34
ATtiny 2313V clock stops @ 3V supply
JC, Thanks for suggestions. They are good clues to root the problem, oscillator or supply. regards, Manuel Silva
Monday, 2 August 2010 - 23:15
AVRStudio Simulator and AVR C library
JohanEkdahl, I understand your point. Any way, I want thank you for your help. Regards, Manuel Silva
Monday, 2 August 2010 - 23:06
AVRStudio Simulator and AVR C library
JohanEkdahl, Converting this library from C++ to C may be a easy task for you, but, as I told before, I am just trying to start in C, so, it is an impossible task for me. I do not...
Monday, 2 August 2010 - 22:39
ATtiny 2313V clock stops @ 3V supply
I use a 10k ohm resistor from reset pin to VCC. thanks. Manuel Silva
Monday, 2 August 2010 - 21:34
ATtiny 2313V clock stops @ 3V supply
Kleinstein, thanks for your suggestions. I use a 33Khz IR frequency and a xtal of 4.194.304 because divided by 127 (0x7F) I get 33.026Hz, very close to the transmission frequency...
Monday, 2 August 2010 - 21:08
AVRStudio Simulator and AVR C library
JohanEkdahl, Thanks for your opinions and inputs. I am going to follw your advise and use only the AVRSTudio once it does all the work. The link to the Arduino library to DOGM16X...
Monday, 2 August 2010 - 20:52
ATtiny 2313V clock stops @ 3V supply
Thanks for your suggestions. I already read the fuses setup and I have the BOD disable. Any suggestions to solve the problem apart from the BOD enable with higher voltage than...
Monday, 2 August 2010 - 15:54
ATtiny 2313V clock stops @ 3V supply
Thanks to all, Yes what I want to mean is AVRISP. I need to solder direct into the PCB because the PCB is so small that I didn't left space for 3X2 pins with 0.1 space. This...
Monday, 2 August 2010 - 14:48
ATtiny 2313V clock stops @ 3V supply
Clawson, Thanks for your inputs, it is a good question. I am not sure if BOD is enable and what voltage. I need to solder the JTAG pins to check it. I will let you know. thanks...
Monday, 2 August 2010 - 13:06
ATtiny2313V Power-down Comsumption
Hello All! LECONS LEARNED: The Power-down do not work with the Debug Wire Enable. In order to the device enter Power-down, e need to disable the debug wire. Thanks to all Manuel
Wednesday, 1 October 2008 - 14:29

Pages