Post Created date
Function Help
Hello. Thanks to all. I did the suggested changes and the program its working. Now, I am going to do a routine to measure the revolutions per minute of a propeller using the...
Wednesday, 2 February 2011 - 22:56
Function Help
Thanks to both of you. I understood that I had to change the variable (array) to a volatile type, but I thought that it was necessary to do some thing else. Thanks again. Manuel
Wednesday, 2 February 2011 - 21:11
Function Help
Hello all. Thanks for your suggestions. Kartman, thanks for your help. The program you suggested is really a much more clean and intelligent solution. I am a "Zero" in terms of...
Wednesday, 2 February 2011 - 19:37
Function Help
Hi Bobgardner. The GPS is sending at 38400. I set up it for this baud rate using a MTK command. If redirect the output from UDR1 to UDR0 directly I can read all the information....
Wednesday, 2 February 2011 - 00:46
SPI problem or lack of knowledge
IndianaJones, thanks again for the help and explanation. Now I am going to try make the additional software to read a GPS data at 384000 Baud Rate and send it down stream at the...
Friday, 21 January 2011 - 20:29
SPI problem or lack of knowledge
IndianaJones11, till now, I only study test conditions (if else, else if switch, case break,), Cycles (while, for, do..while, break, continue return, etc), functions and...
Friday, 21 January 2011 - 15:37
SPI problem or lack of knowledge
IndianaJones11, Thanks for your help. I am going to use your suggestions. I already had suspected that the pointer should have the same size of the variable. Thanks again. Regards...
Friday, 21 January 2011 - 10:13

John, thanks for the additional in formations. Regards, Manuel
Saturday, 1 January 2011 - 22:06

John and David, thanks, after make the correct connections the debug environment it is working with the JTAGICE MK2. Thanks, Manuel
Friday, 31 December 2010 - 16:18

John and David, thanks for your inputs. I am using a board that I design myself. I have been working with the atmega48, 88, Attiny13A and Attiny2313. I only did ASM programing and...
Friday, 31 December 2010 - 12:17

John, Thanks for your reply. It is a protoytpe board. I have the JTAG connected in the following way: MCU.......JTAG MKII MOSI........TDI MISO........TDO SCK.........TCK Reset...
Thursday, 30 December 2010 - 22:08
USART Interrupt
Bobgardner, RPM stands for Rotation Per Minute. Thanks and regards, Manuel
Thursday, 23 December 2010 - 18:10

Pages