Post Created date
Dual CAN?
look at the MCP2515 SPI cancontroller from microchip, the you could have several can on the same spi bus
Thursday, 19 October 2006 - 06:24
voice bandwidth
SPeech is from 10Hz to 3400Hz, did speech recognition in matlab once. there you can do a fourier transform of he signal, and clearly see which freq, is used. but yes you can hear...
Friday, 9 June 2006 - 06:34
ADC conversion of a sine signal
analogdevices have an excelent true RMS converter in ther chips programme. it vil take a sine / square/triangle wave at 1volt max, and convert it to a value you can measure using...
Tuesday, 30 May 2006 - 10:27
Writing to a "partial" port?
cant u just use defines to make a virtual port eg port G that is 6 bits vide and i mapped to PORT D lower 6 bits ??
Tuesday, 16 May 2006 - 16:22
Change USART pins.
you could make at virtual port E foreksample, at define it as havind bit 0-5 on port D and 6-7 on port C eg. the you wire the disp to the 6 bits on portD and 2 bits on C, and...
Wednesday, 26 April 2006 - 15:44
extended I/O map Registers dont work on my ATmega 128
check that the 103 compatibility mode fuse is not set, is default on, but should be programmed of to use all mega 128 features.
Tuesday, 25 April 2006 - 07:11
Program ATtiny2313 (and others) through RS232 port
check the tiny data sheet to see if it supports bootloader, else make the programmer, and yes you can use the rs2323 to ttl converter (max232) the pprogrammer supprts almost...
Monday, 24 April 2006 - 10:02
Program ATtiny2313 (and others) through RS232 port
the rx and tx lines going from FTDI to mega 8 is th eonly two lines needed, those you connect to the max rs232, det other control lines frm ftdi to mega 8 is to bitbang program...
Monday, 24 April 2006 - 09:19
Program ATtiny2313 (and others) through RS232 port
Hi I use this one http://tuxgraphics.org/electroni... I replaced the FTDI USB chip with a simple max rs232, so i use it simply as a serial programmer, works just like an AVRISP
Monday, 24 April 2006 - 08:15
proble loading code into AT90CAN128 general purpose board
try lowering the ISP freqency under the Board Tab, to something lower than 1/4 of CPU freq, maybe the internal RC oscillator is set too low.
Tuesday, 11 April 2006 - 11:58
Which I2C library
the question is which I2c library for an ATmege32 that compiles using winAVR would people recomend, like avr-lib or something.
Wednesday, 5 April 2006 - 07:47
insystem programming ATmega 128
on mega128 til programming ports isen't the spi port but the pins PE0 PE1 PB1 and reset theres a note on it in the mega128 datasheet too.
Tuesday, 21 March 2006 - 07:17

Pages