Post Created date
None of my Tools are working after upgrading to Studio 7.
Native install or virtualized Windows?   If you downloaded the offline installer, I would recommend that you download the web installer and do a uninstall/repair without any...
Thursday, 21 September 2017 - 06:02
Atmel ICE "Failed to enter programming mode"
Did you successfully use debugWIRE before this attempt? Because if you are trying to debug an arduino with a serial chip on, you will have to remove the mentioned 0.1µF capacitor...
Sunday, 17 September 2017 - 06:00
Toolchain and IDE in container
clawson wrote:I don't use it for AVR (too trivial) but in day job I use docker a lot. Also using Eclipse as the IDE for the source and compilers/debuggers in the docker container...
Sunday, 17 September 2017 - 05:50
Change the Prescaler Division of de Main Clock in ATtiny817
awneil wrote: meolsen wrote:_PROTECTED_WRITE()   AVR Libc Reference Manual wrote: Write value value to IO register reg that is protected through the Xmega...
Friday, 15 September 2017 - 19:28
Change the Prescaler Division of de Main Clock in ATtiny817
meolsen wrote: Better to use _PROTECTED_WRITE()   I need to read the manual better. Tusen takk for den! 
Friday, 15 September 2017 - 19:00
Change the Prescaler Division of de Main Clock in ATtiny817
Just tested setting clock on a ATtiny817   CPU_CCP = 0xD8; CLKCTRL_MCLKCTRLA = CLKCTRL_CLKSEL_OSC20M_gc; CPU_CCP = 0xD8; CLKCTRL_MCLKCTRLB = 0x1;Confirmed as 10MHz  
Friday, 15 September 2017 - 17:03
Change the Prescaler Division of de Main Clock in ATtiny817
Rodri_Go11 wrote: I think that the problem is not here...... :/. What do you think?    Thank you very much   10.3.5 Configuration Change Protection This...
Friday, 15 September 2017 - 12:43
Once again: Debugging with GDB
clawson wrote: Talking of DDD. One of my most recent uses for it was here:   https://www.avrfreaks.net/comment...   That thread is fairly self explanatory - for those...
Monday, 11 September 2017 - 15:25
How is debugWire (DWEN fuse) unprogrammed
allano wrote: shows that the DWEN fuse has been 'disabled' while in the debugWire mode.   So I assumed that the uC is still in the debugwire mode until power is cycled....
Monday, 11 September 2017 - 15:17
Once again: Debugging with GDB
It works.. But, does not stop by itself on break. Have to run until it hits, then CTRL + c. DDD was a really nice GUI for GDB by the way.
Monday, 11 September 2017 - 12:41
How is debugWire (DWEN fuse) unprogrammed
JohanEkdahl wrote: Anyhow... If I get this right this means the process of getting into, and out of, debugWIRE with AVaRICE means:   1. Use AVRDUDE to program DWEN 2. Start...
Monday, 11 September 2017 - 08:10
How is debugWire (DWEN fuse) unprogrammed
avrdude handles this automatically, you just have to set the fuses manually.   If the target AVR has been set up for debugWire mode (i. e. the DWEN fuse is programmed),...
Monday, 11 September 2017 - 06:10

Pages