Type in the full discussion title or a part of it.
Discussion Title Created date
How to set up two build targets
 Hello,           Answers to this question are hard to search for via Google because they get drowned out by product literature for Atmel Studio 6...
Wednesday, 25 March 2015 - 20:38
EEPROM question
Hi there, I'm putting together a circuit that uses several AVRs. I'd like to program them all with the same code, but I'd like each one to run a different section of that code...
Monday, 4 October 2010 - 17:50
Why can't I write to SPDR and SPCR?
Hi there, This is probably something simple, but I hope someone can point out what I'm doing wrong. I'm trying to configure SPI on an ATmega328p, using WinAVR (I have the...
Thursday, 9 September 2010 - 14:42
Best Hakko tip for fine soldering?
Hello, I was just wondering which tip Hakko users around here use for very fine SMD soldering.
Tuesday, 16 March 2010 - 13:15
Signal conditioning problem
Hello, So I've been messing around with the Atmega128's ADCs, and I have a signal conditioning problem. My sensor emits data between -4V and +4V, while the ADCs in question can...
Thursday, 2 July 2009 - 13:14
Clarification on differential ADC result
Hello, I hope someone can clarify my understanding on how the differential measurements on the mega128 work. I have a sensor that emits analog data at +/-4V. From my reading of...
Wednesday, 1 July 2009 - 01:05
ADC works in debug mode, but not elsewhere
Hello, I'm trying to write a program for the ATMega128 that continuously samples from six ADC channels and then transmits the results over a UART. The code I have so far...
Monday, 29 June 2009 - 13:41
Does 400F seem a little hot for a min soldering iron temp?
Hi, So I just got my brand new Hakko FX-951 in the mail, and upon reading the manual, have found that the lowest temperature it will maintain is 400F. I typically set my iron...
Tuesday, 26 May 2009 - 14:35
Where do you go to read about servo control theory?
So it isn't that hard to slap together a PID loop running inside an Atmega-8 and wait for the millions to roll in from your ad in the back of Nuts & Volts. However, there's...
Sunday, 10 May 2009 - 12:01
Digikey has XMegas in stock
...A couple hundred yesterday, down to about a hundred today.
Friday, 8 May 2009 - 12:38
Must we replace /usr separately, or at all?
So I noticed that I can make myself a functioning system by flashing only the -root portion of the image that buildroot creates. The wiki says that the next step is to install...
Saturday, 25 April 2009 - 13:52
Are AP7000 inputs 5v tolerant?
Hello, Should I bother with level shifting if I'm reading data from 5v devices with an NGW100 (via the GPIO headers, which seen to be connected directly to the chip)? I would...
Friday, 17 April 2009 - 15:26

Pages