Post Created date
Writing to flash in run time
Why do you think you want to do this? Or is it just an academic interest?
Wednesday, 1 September 2010 - 06:44
Atmega168 trouble
Add a .include "m168def.inc" right at the top of your program. That will allow you to use PORTD, PINC etc So you wrote the code in you first post by hand? What are the "......
Monday, 30 August 2010 - 23:07
[MAN] [HARD] Basic Mega16 Circuit
I doubt it - you must be the first person to ever want one of those... EDIT: Oh, Cliff's post shows that they have been done before. I'm amazed :D :D :D
Wednesday, 25 August 2010 - 13:48
How to count Clock Cycle of a procedure?
...assuming of course that your procedure is pretty much straight line code or predictable loops (i.e. without variant loops or branches) so that whatever data it receives or...
Sunday, 22 August 2010 - 09:02
ASM Newbie: weird initial results, what's going on?
I can't see why it doesn't work - writing to PINB is valid according to the ATTINY25 data sheet and will toggle the outputs. I'm confused about gcc and your code being in ASM - so...
Friday, 20 August 2010 - 22:40
How getting rid of staircase from DAC?
I thought RES wanted to keep the staircase, but wanted the slope to be a straight line rather than stepped. But the requirement is not clear....
Thursday, 19 August 2010 - 21:34
How getting rid of staircase from DAC?
http://www.lmgtfy.com/?q=dac+sta... First entry - just need to get your LPF time constant right - lower C probably...
Thursday, 19 August 2010 - 21:09
Simple Low cost programmer for flash and Fuse updates
alank2 wrote:I use it with Windows 7 x86 and the latest version of Studio but is it 32-bit or 64 bit? I have 64-bit which I installed on the basis of "bigger is best" but have had...
Thursday, 12 August 2010 - 19:07
Simple Low cost programmer for flash and Fuse updates
Is the Sure V2 the one at http://www.sureelectronics.net/g... - doesn't seem to mention V2 anywhere. Is it guaranteed to install on Windows Ultimate x64 - which needs signed...
Thursday, 12 August 2010 - 17:43
Unable to program flash command failed
Quote:I connected the oscillator to XTAL1 and Xtal2 with caps in between the oscillator and gnd. I was told polarity doesn't matter with the oscillator.So you connected a crystal...
Wednesday, 11 August 2010 - 14:17
[Help] Frequency and low voltage as ADC Input
New oil = clear; old oil = opaque. Partly true New oil = no suspended metallic particles; old oil = suspended metal particles from system being lubricated. True New oil = no...
Thursday, 5 August 2010 - 17:11
LED sensing
...and have you checked the voltage on the ADC pin with your multimeter to decide where the on/off transition point should be?
Monday, 26 July 2010 - 15:49

Pages