Post Created date
3 phase High voltage ac to low power 5V dc out
I haven't followed this thread, but Bigclive tested a 3phase PSU recently. You can find him on Youtube.
Monday, 19 October 2020 - 18:07
Content mismatch when using serial but nor on ISP
So unless you have the V model, you are limited to 4.5-5.5v?   Yes, Curt. Bugger huh ?   I once needed a Mega2560 to run from a LiPo, and since all AVR-types I used so...
Friday, 5 July 2019 - 00:51
Content mismatch when using serial but nor on ISP
avr-mike wrote: The maximum frequency spec. in the datasheet at 3.3V is 8MHz.   --Mike     Re-check, Mike. Mega2560's are "special", Vcc-wise. It bit me once...
Friday, 5 July 2019 - 00:30
Content mismatch when using serial but nor on ISP
Just in case you missed my post ....   From the datasheet:  
Thursday, 4 July 2019 - 23:40
Content mismatch when using serial but nor on ISP
I am running W10 Home v1803 on a 12 core Intel I9-7920X @ 2.9GHz with 64GB ram, but I am pretty sure avrdude wouldn't use all the cores anyway, so who knows. I really can't...
Thursday, 4 July 2019 - 23:20
Content mismatch when using serial but nor on ISP
@newhobby et all   Ran into the same problem a few weeks ago. Being an old fart*) I didn't want to give up on sorting out this problem. So I tested on several PC's with...
Thursday, 4 July 2019 - 22:42
Re-formatting an unrecognised SD card
O yes, I am very much alive. Or at least that is what I think I am (reference to The Hitchhikers Guide of the Galaxy)     Thanks
Tuesday, 4 June 2019 - 17:40
Re-formatting an unrecognised SD card
I noticed this post just when one of my USB flashdrives stopped working. So I tried the procedure as posted by Bingo. It worked ! BUT: I wasn't able te create a new "msdos"...
Monday, 3 June 2019 - 21:09
Toroid Coil Calc's
Hi Jay,   The l stands for the length of the magnetic field lines, not the length of the wire. The spacing of the winding has (theoraticly) no effect on the inductance....
Saturday, 17 November 2018 - 20:15
Funny how that works....
ki0bk wrote: The "wire" went bad!  or the contact in the BB got flaky and moving (replacing) the wire brightened the contact for a few more hours!  q:-(  I so dis-...
Thursday, 23 March 2017 - 18:12
Higher Voltage of Low-Logic Level and Unclean Output from ATTiny2313
My guess: OP uses fastPWM mode. He'd better use Phase and Freq correct PWM instead. PWM frequency drops to half but the good news is that 0% PWM == LEDs OFF. This is described in...
Sunday, 19 February 2017 - 12:39
TWI 0x20 nack
crosspost
Friday, 2 September 2016 - 05:49

Pages