Type in the full discussion title or a part of it.
Discussion Title Created date
Should I do a new product design with SAM3x8? (Arduino Due board)
I would like to make a new design for my device that I would like to be using for the next 5-10 years. I chose the Arduino Due board with SAM3X8 microcontroller which should...
Thursday, 1 February 2018 - 13:59
SAM V71/S70 incorrect USART baudrate (half speed)
I have followed the ASF samples to configure my USART module in SAM V71 on Xplained Ultra EV kit. However, the actual baudrate is always half of what I configure.   #define...
Tuesday, 16 August 2016 - 14:49
Simple or minimal SAM S70/E70/V71 hardware design example
For a new project I am designing hardware with SAM S70 MCU. I have purchased Atmel Xplained Ultra with SAM V71 MCU and I have available its full schematic. However, I find this...
Monday, 15 August 2016 - 15:21
Difference between EDBG and J-Link (Serial Wire Debug) debugging and flashing
I am currently working on a new board design with Atmel SAM S70 Cortex M7 and I am trying to figure out what is the best way to program and debug it. The development kit with SAM...
Monday, 8 August 2016 - 20:45
Is Atmel support dead?
For at least a month so far I cannot create any support case from here: http://www.atmel.com/design-supp...   Every time I click "Open support case" I get: The page you have...
Monday, 4 July 2016 - 15:36
Library for driving LCD via FT813 for Cortex M7 (or M3, M4)
Is there any library available that I could use for controlling an LCD via FT813 chip for Cortex M7 (or M3/M4)?   Thank you.
Monday, 30 May 2016 - 21:15
Xplained extensions for SAM V71 Xplained Ultra
I am starting new development with SAM S70 and for that I will purchase SAM V71 Xplained Ultra evaluation kit. I need to connect a few devices over USART, some on SPI, connect...
Sunday, 22 May 2016 - 22:52
UC3 vs ARM in 2016
I have been using UC3 for previous projects in the past and also wanted to use the UC3 in future. We are starting development of a new device now. Basically we need to be reading...
Saturday, 21 May 2016 - 08:14
Graphical LCD display selection
Hi all, I am working on a project with Atmel UC3 chip. Now I need to choose and integrate a graphical LCD. My requirements are: screen size around 4" (3.5"-4.5"), resolution...
Monday, 14 December 2015 - 16:35
Upgrade FreeRTOS in Atmel Studio from v7 to v8
Hi, I have created and successfully ran a few projects with FreeRTOS + lwIP in Atmel Studio 7. However, the FreeRTOS used in the samples is the version 7 about 3-4 years old now....
Saturday, 17 October 2015 - 07:39
Problem with FreeRTOS+lwIP+USART on EVK1100
Hi, I am working on my first Atmel UC3 application on EVK1100. What I need to achieve is serial port (UART) functionality (receiving and sending data) together with TCP/IP socket...
Saturday, 10 October 2015 - 09:28