Type in the full discussion title or a part of it.
Discussion Title Created date
Free shipping for Atmel parts
And, of course, Microchip parts.    Just got an email with this information for microchip direct store:   Apply the following Coupon Code at the Checkout ALLNEW17 (...
Thursday, 2 March 2017 - 12:50
LI-ION battery charger help
I have an interesting design coming up. There are two batteries. An internal LI-ION and an externals LI_ION. Both single cell. The internal battery is charged by the external...
Thursday, 30 January 2014 - 20:44
Single chip micro and RF
I am in the early design phase of a project that will require a single chip solution RF transceiver and micro which will control a motor and various housekeeping duties. I see an...
Tuesday, 19 June 2012 - 14:12
USB cable supplier, USB wall wart supplier
I am working on a high volume project that requires a USB cable with a type A connector on one end of a 1 meter cable, and a strain relief on the other with leads coming out. 15K...
Tuesday, 31 January 2012 - 17:04
PCB assembly houses
I have the need to find a PCB assembly house in the USA that has the ability to build 15,000 small PCB's a month. Have any of youse had any experience with any companies that do...
Tuesday, 31 January 2012 - 16:53
Software testing for RTC time setting
Software testing is a bit new to me and I was hoping to get some better ideas on how to test a RTC routine in an embedded system. There is a serial command line interface to set...
Thursday, 11 August 2011 - 13:11
JTAG debug code works, JTAG program code does not
I am using an AT90CAn128. When I use my JTAG ice mkII as a debugger, all is well. (Code cycles through lighting LED's as it should. Simple test.) If I unplug the debugger, all is...
Wednesday, 1 September 2010 - 20:42
mixed C and assembler output
I am in the midst of writing some code and would like to convince AVR GCC to output files with mixed C and assembler so I can see how the compiler is handling my C code. I tried a...
Wednesday, 23 June 2010 - 13:41
DVK90CAN1 firmware
I am just starting to use this CAN demo kit. It has been used by someone before and I did not find any demo firmware for it. I am using GCC and was hoping someone out there might...
Friday, 7 May 2010 - 16:08
NiMH battery charger
I need an integrated battery charger for a NiMH battery pack of 4 series cells. They are high capacity cells, over 10,000 mAH. Input voltage is 7-36 volts. 28 volt nominal. I...
Tuesday, 27 April 2010 - 12:53
Board for embedded linux
Hello, I want to get into embedded Linux. I am looking for a board that will allow me to do so. I have seen the NGW100, which seems like it will allow me to get into it. I was...
Friday, 20 March 2009 - 13:53
JTAG ICE mkII works. JTAG ICE clone will not connect.
I have been using the JTAG ICE mk II for a year on this same project. We purchased a couple of LEDZ JTAG ICE ISP clones so we could have production AND engineering be able to...
Wednesday, 4 October 2006 - 18:08

Pages