Post Created date
Atmel 328 Timer0
Thanks for all the very helpful responses!  I am much better off than I was.   Dave
Thursday, 6 September 2018 - 21:30
Atmel 328 Timer0
Thanks, El Tangas.   kk6gm   I looked into using Input Capture but it seems that the 328 has only one Input Capture pin but with RC Servos, in my case, I need to be...
Sunday, 2 September 2018 - 21:49
Atmel 328 Timer0
I understand  of what you describe here kk6gm but just to be clear, I was not concerned in this experiment about missing interrupts, I just want to see how...
Sunday, 2 September 2018 - 20:18
Atmel 328 Timer0
Jim, Good question, ultimately I need to be able to measure a 1000us to 2000us pulse width accurate to perhaps 100us for radio controlled motors.  Can this be done on a 328...
Sunday, 2 September 2018 - 19:20
Atmel 328 Timer0
Thanks, Jim, I also realized that I should set the counter back to zero right after resuming interrupts.   Now I am getting 39 in the timer counter consistently except ever...
Sunday, 2 September 2018 - 19:11
Code conversion
Coming from the transmitter is a pulse representing a roll command on one channel and a pulse representing pitch on another channel etc.   The roll pulse if being converted...
Wednesday, 11 July 2018 - 23:16
Code conversion
Jim, The ROLL_RX_Mult is 20/400 as explained.   How is this main calculation calculating in degrees?  I do not follow the conversion from micro seconds of the pulse to...
Wednesday, 11 July 2018 - 23:12
Code conversion
Sure:  https://www.dropbox.com/s/chxlf2...   I think I need someone who knows the ADXL345.  
Wednesday, 11 July 2018 - 22:19
Code conversion
The 400 may be from the I2C speed of 400KHz.  I just noticed this but no idea where the 1500 comes from.  
Wednesday, 11 July 2018 - 21:47
Code conversion
Thanks, Awniel.   I have looked at the ADXL345 data sheet and I find no hints that might help.  Code came from a web published project.  
Wednesday, 11 July 2018 - 21:31
How to create a libarary in Atmel Studio 6
If I right-click on the project in the solution explorer and choose properties, I get   Common Properties      Startup Project     ...
Tuesday, 26 December 2017 - 22:57
How to create a libarary in Atmel Studio 6
Thanks for this hint but I just went carefully through all the menus in Studio 7 and there is no "C/C++ Compiler Section"   How does one get to the C/C++ Compiler Section in...
Tuesday, 26 December 2017 - 21:52

Pages