Post Created date
Latching Relay vs Flip Flop
Hi,   Thanks for all your inputs.   I cannot go the latching switch route, because I have already cut the control board interface and fitted a standard on/off push...
Monday, 13 November 2017 - 12:09
Latching Relay vs Flip Flop
Hi,   This circuit will sit in between a 5V switch in a control board and an ecu module.  This circuit needs to remember its state on power down.   Circuit...
Monday, 13 November 2017 - 10:24
CTC Opeartion Issues
Hi,   All solved, you were correct it was a GND issue.  It is always nice to have someone else's input.  I was adamant it as a software problem.   Anyway,...
Monday, 12 September 2016 - 18:35
3.3V to 1.8V problems
Hi theusch,   So my project is nearly finished, and I am just trying to put it into low low power mode.   I had a bad power consumption problem, and a design over-site,...
Wednesday, 7 September 2016 - 19:57
3.3V to 1.8V problems
Brian,   Yes I am dividing by two in CLKPR.  This works correctly at 3.3V.   Theusch,   BOD: I did see there is not a safe level for 1.8V, but I tried...
Wednesday, 7 September 2016 - 18:36
3.3V to 1.8V problems
Hi Brain,   I am using the internal oscillator.   So you think 4MHz, 9600 baud, 1.8v should be ok?   thanks.
Wednesday, 7 September 2016 - 16:14
3.3V to 1.8V problems
OK after double checking the chip, at some point it has moved from an ATmega324P to now using a ATmega324PA AU1522.   Yes I have tried changing the BOD levels but not luck....
Wednesday, 7 September 2016 - 16:01
3.3V to 1.8V problems
Hi Valusoft.   Well this could be my problem!!   What page did you find that on?   On page 2 of the datasheet (ATmega164A/164PA/324A/324PA/644A/644PA/1284/1284P )...
Wednesday, 7 September 2016 - 14:14
3.3V to 1.8V problems
Hi,   page 324 displays I am right on the edge of working.  should I therefore drop my clk speed?   thanks
Wednesday, 7 September 2016 - 14:07
3.3V to 1.8V problems
Oh sorry, its a ATmega324P   Just trying to find the voltage baud cross over.
Wednesday, 7 September 2016 - 14:04
Low Power I2C problems
Hi,   Thanks for all your help.   I will work through all the above tests.  Then when I am out of options, I will post my schematic.   Thanks again for all...
Thursday, 25 August 2016 - 17:14
Low Power I2C problems
Hi, Kiobk I recognize your logo from another forum.  I thought you used to be called Ric.  OK wrong person.   I am measuring the current using a DVM current meter...
Wednesday, 24 August 2016 - 16:18

Pages