Post Created date
I want to modify the return adress of the Program Counter
To solve the problem Theusch brought up, I would think you could turn interrupts off for all but the main loop, That would mean cli and sei before and after every subroutine call...
Sunday, 30 July 2006 - 15:40
1wire Serial Voltage
I made an error it works fine. I had a typo in my filename, the status read 0, I did not notice it. The error said the first byte... and I thought it must have read the file,...
Sunday, 30 July 2006 - 04:03
Why no Attiny24?
Thanks KKP.I have another thread going on this, It started with Voltage question, but the last post by me has the question I posted here as well. I did use the rjmp to bootloader...
Sunday, 30 July 2006 - 03:19
Why no Attiny24?
I have some samples of 24's 44's and 25's. I had asked for samples of the 25's for a project and they accidently sent me some 44's and 24's PM me with your address and I will mail...
Saturday, 29 July 2006 - 17:13
1wire Serial Voltage
A small problem After it tests relibility I get the message "First instruction looks like it's incorrect" Code below (myprogram) very first instruction is rjmp to bootloader Not...
Saturday, 29 July 2006 - 05:50
1wire Serial Voltage
Perfect, thanks to both. I get 5.44 peaks now Now on to the actual programs
Saturday, 29 July 2006 - 03:38
Fab House recommendations
Forgot to mention, I am in Minnesota, USA but i will check Active-PCB out, Thanks.
Saturday, 22 July 2006 - 16:02
Tiny Adaptor Boards (may be off topic)
Yes but for example in the original post, the NUD4001 requires a resistor across two of its pins and 4 of its pins can tie together for output adding a surface mount place for a...
Thursday, 20 July 2006 - 16:08
8-SOIC .015 or .0209 How do you spec.
Ahhh Hugh I see my package says ATTINY13V-10SU and page 161 of the datasheet I have tells me the package is an 8S2 and page 163 says its a .0209 Wide body. Very nice, thank you...
Wednesday, 19 July 2006 - 00:11
[CODE] [ASM] Timers Macros PUSH POP
Cant seem to attach two files, here is the macro file .macro high4 sbi portb, 0x04 .endmacro .macro low4 cbi portb, 0x04 .endmacro .macro high3 sbi portb, 0x03 .endmacro ....
Monday, 17 July 2006 - 02:00
ADC quits working program continues to run
Quote:) If "voltsout" (somehow) becomes 16, it will not be detected, but rather PB4 (ADC2) will be set to output, which I'm pretty sure will affect its ADC results. I think you...
Thursday, 6 July 2006 - 16:51
ADC quits working program continues to run
Reads the adc, left adjust so 8 bit resolution, I then take from 255 to 238 and set voltset to 0 then next range 238 to 221 is voltset=1 and so on down to voltset=15 where all...
Thursday, 6 July 2006 - 14:39

Pages