Discussion Title | Created date |
---|---|
Another 8BIT programmer trying to get up to speed with 32bit I have waited a year before delving into the 32 bit world. I took a few days and tried for 2 days to get a handle on what to start with and then thought perhaps I will wait... |
Monday, 18 August 2008 - 01:26 |
Nasty negative voltages on PWM pin Long time no post I have been on a break. Back at it again with a new design for my simulated rotating light. This time it is going to rotate though. I found some 4 RPM motors... |
Wednesday, 16 April 2008 - 08:28 |
External capacitor timer I am working on a project that will use a button battery. I have selected the Tiny13V using 128k internal clock with a clock prescaler of 256. If I use idle mode and the timer... |
Monday, 14 January 2008 - 03:08 |
I am having a problem with phase corrrect PWM mode 5 Tiny45 The scope and debugger show The OC0A pin set high the first compare match TCNT0=OCR0B and then clears it at top=OCR0A and never sets it again although at OCR0A it reverses and... |
Wednesday, 31 October 2007 - 05:59 |
JTAG Speed and number of breakpoints I am now using ont of the Futurlec et-AVR mega128 boards and their JTAG programmer, it was 10 x less money than the AVR jtagIce markII I have in my programmers drawer that I never... |
Friday, 19 October 2007 - 04:15 |
Question on Sram datalines I am using a W24129A static ram, the datasheet does not show how to connect the microcontroller to the sram chip and i have just directly connected the pins. Right now before I... |
Tuesday, 16 October 2007 - 09:35 |
Some trouble with tiny2313 250kbps at 20MHZ USART 20MHZ crystal tiny2313. I am having trouble using the tiny2313 USART to read output from the PC, two problems. Using the code below, I get two bytes output when i am only sending... |
Tuesday, 16 October 2007 - 01:20 |
Com port and serial IO with AVR question I am having a problem with opening a com port from windows when the serial port is not connected to anything. When I connect it to my stk500 even if it is off the open commands... |
Tuesday, 2 October 2007 - 08:42 |
Initial design Java--Serialout--Tiny2313--DMX RX/TX BaudRate I would like any input you might have on my initial design idea. i am using java and a serial port package to control a Tiny2313 set up to receive light level data via serial port... |
Friday, 28 September 2007 - 08:13 |
PWM, Capacitor filters and LED's I have been searching for a metal container/box that I could put my DMX controller and Luxeon LED's in and I came up with using an off the shelf external disk drive housing. The... |
Wednesday, 22 August 2007 - 16:39 |
Are port B6 and B7 disconnected when fuse Ext. Crystal? I am using Mega48 with external crystal and port B bits 0..5 as outputs. If I OUT portb,r16 does it matter if bits 6 and 7 are on or should I mask them before the OUT or use SBI... |
Tuesday, 31 July 2007 - 06:24 |
Need help with reference to ground voltage reading ATinys I am working on an avr digital current meter idea. I use a resistor network to drop the voltage to the pin threshold to switch from charging one capacitor to transfering the... |
Sunday, 22 July 2007 - 04:42 |