Post Created date
Dual bank compiling and linking for firmare upgrades
hs2 wrote: Double check that you’re not unintentionally call code in flash after switching banks !   That was is. I was switching the bank within RAM, but oif course,...
Sunday, 24 May 2020 - 10:33
Dual bank compiling and linking for firmare upgrades
I have one remaining issue with this. When I have swapped to the other bank, after reprogramming I have to power off and on again. I am sure I read that it should just reset and...
Saturday, 23 May 2020 - 13:03
Dean's Atmel Studio Extensions
Ah, understood.   I think from that document, it's not what I'm aftar though - I don;t even think you can have warnings shown there. I still  think MarginOfError is what...
Friday, 8 May 2020 - 10:29
Dean's Atmel Studio Extensions
awneil wrote: They indicate where you have edited: Unsaved changes are yellow; they change to green after saving the file.   Ah, OK - thanks!   awneil wrote:This is (...
Friday, 8 May 2020 - 09:03
Dean's Atmel Studio Extensions
Mine puts some seemingly random green lines in the left hand margin, but there's no indication of why they are there and they are soemtimes on lines with comments, so that doesn;t...
Friday, 8 May 2020 - 08:52
Dean's Atmel Studio Extensions
Sorry for adding to an old thread; I'd really like ot use the MarginOfError but I can't see how you even install it after you've downloaded. It all looks pretty locked down to...
Friday, 8 May 2020 - 08:21
How do I watch an array as ASCII values, not hex or decimal
Are you thinking there might be a bug for this processor?
Thursday, 7 May 2020 - 07:57
How do I watch an array as ASCII values, not hex or decimal
meolsen wrote: What device would this be for?   SAM4C32C
Tuesday, 5 May 2020 - 07:25
How do I watch an array as ASCII values, not hex or decimal
Assuming you mean like below, it's still not working for me.  
Monday, 4 May 2020 - 23:10
How do I watch an array as ASCII values, not hex or decimal
  Sorry for the delay. Been busy doing non-ASCII stuff.   So, there is a line:   strncpy(sparams.cafile, NETWORK_SERVER_ROOT_CA_FILENAME, sizeof(...
Monday, 4 May 2020 - 16:18
Dual bank compiling and linking for firmare upgrades
OK, I have it working. I think it's a bit of a mind **** and spectacularly badly described in the datasheet and safe and secure bootloader, so I'll try and explain how I see it...
Friday, 1 May 2020 - 15:34
Dual bank compiling and linking for firmare upgrades
OK, I must have some other issue then because I've definitely managed to set bit 2 and it just falls over. I've done exctly as you said command wise and run from RAM.   I'm...
Thursday, 30 April 2020 - 17:43

Pages