Post Created date
IoT Design Week 2020
js wrote: Guys it's a VIRTUAL seminar so you only get a virtual board......   The best kind of board! Zero hardware problems
Saturday, 7 March 2020 - 21:23
IoT Design Week 2020
Too late to hope for a nice AVR-BLE board?
Saturday, 7 March 2020 - 05:57
Please recommend IDE for atmega microcontroller
Simonetta wrote: Plus it's free,  and it ... just .... f***ing ....works.   Used to think so too, until a couple of days ago when I found - the hard way, of course -...
Wednesday, 4 March 2020 - 12:23
PIC programming
If you can wait for slow shipping, cheap PICKIT3 clones from China will do the trick, they're about $12 last time I checked.
Friday, 22 March 2019 - 16:05
micro-SD memory block behavior?
clawson wrote: Yes, it'll do that.   Cool, thanks!   clawson wrote: Even magnetic HDDs from Seagate and Western Digital have been doing thus same remapping thing for...
Monday, 22 October 2018 - 23:08
micro-SD memory block behavior?
clawson wrote: All this is "hidden" inside the operation of the SD controller. To the outside world floppy disks, hard drives, SSDs, SD/MMCs appear as just a "sea" of completely...
Monday, 22 October 2018 - 20:53
Mega4808 External Low Frequency Crystal Oscillator?
I wonder how will the MCU ever be able to tell, all by itself, whether it's connected to a 32.768KHz or 32.0KHz crystal :-)   Just remember that if you're going to use the...
Thursday, 27 September 2018 - 22:46
atmega4809 ADC example code
For what it's worth, here's a simple quick-and-dirty code I just wrote and tested on an ATmega4809. IDE is Atmel Studio 7.0.1931. I only include the ADC-related parts, and...
Thursday, 20 September 2018 - 23:23
ATtiny1616 USART TX interrupt flags: is it me or the datasheet?
kabasan wrote: TXCIF in USART0.STATUS is not automatically cleared. I confirmed the operation with real chip.   The 4809 too? Good thing you caught it, I was about to start...
Monday, 20 August 2018 - 08:28
ATtiny1616 USART TX interrupt flags: is it me or the datasheet?
kk6gm wrote: Since writing a 0 to any other bit in the register has no effect, just write  USART0_STATUS = USART_TXCIF_bm;These kinds of flag registers are very common in...
Saturday, 18 August 2018 - 19:18
ATtiny1616 USART TX interrupt flags: is it me or the datasheet?
theusch wrote: igendel wrote:TXCIF - Set to 1 when the shift Register is done, and no further data is pending in the Data Buffer, i.e. when the IO pin returns to the idle state. I...
Saturday, 18 August 2018 - 19:13
ATtiny1616 USART TX interrupt flags: is it me or the datasheet?
Greg_Muth wrote: You are aware that the following sets str to { 'A', 0, 0, 0, 0, 0, 0, 0, 0, 0 }? uint8_t str[10] = "A";   Yes. This is not related to the issue at hand...
Saturday, 18 August 2018 - 19:00

Pages