Post Created date
mEDBG USB/Serial Baud rates?
Hi, I am not sure about the ATmega32u4. But I had try with the ATmega88PA.   From the datasheet, if I change my external crystal to 11.0592MHz, it can get all the baudrate up...
Thursday, 10 September 2015 - 01:17
Legacy Atmel Studio - Without Microsoft Visual Studio
Hi  You can try this  http://www.atmel.com/tools/STUDI... or  Atmel archive   They had all their old software there. Note that some of the software cannot run...
Thursday, 10 September 2015 - 01:10
Best (easiest, cheapest) RF connection method?
Look like most RF module or IR module will do. Just had to make sure that this module has 4 output to replace the buttons. With 5V supply, this module will be able to work or you...
Sunday, 30 August 2015 - 01:10
Compile old AVR code in ATmel Studiio 6.2
Yes. It had been working since then. Now need to add in another function. So Atmel Studio 6.2 keep giving bug, no problem with AVR Studio 5.
Monday, 24 August 2015 - 00:42
Atmel Studio 6.2 and Atmel Studio 4.18 jungo driver confict
Had you try install the Atmel Studio 6.2sp2?
Sunday, 23 August 2015 - 11:33
atmel studio 6 programmer [busy]?
Hi all, I had this problem too when using ATmel Studio 6.2. At first I thought is my MKII, which Atmel had discon.   Until yesterday, I was doing some setting at the Tools-...
Tuesday, 18 August 2015 - 01:29
Xmega usart using RS485 lines
Thanks Greg,   Is this mean that you advice that both end of the Tx and Rx must be terminated? Will a 120 ohm do the tricks? As for the protocol. Is that I can see that it do...
Wednesday, 3 June 2015 - 01:01
Xmega usart using RS485 lines
Hi Greg, I agree with you that the master at the end of the bus is bad, but I cannot install it in the central. Still need a termination resistor at the end of the bus. There are...
Tuesday, 2 June 2015 - 02:46
Xmega usart using RS485 lines
Hi Steve, I had been looking at this topic since start of this project. It get confuse on the RS485 and RS422, there a lot of different explation on this. Rs422 - I understand is...
Tuesday, 2 June 2015 - 01:08
Atmel Studio_6.2sp1_1502 and AtmelUSBInstaller-6.2.342 fail on Windows 8.1
Hi all, Just some update. I just intall "AStudio6_2sp2_1563net" it solve my win 8.1 fault. Now can detect my MKII. CS
Monday, 9 March 2015 - 02:59
Xmega handheld programmer
Hi Doc., I agree with you too. Just that I had drop them an email, until now no reply.   It is design by Atmel dist. in South Korea, Prochild. http://www.prochild.com/eshop/...
Wednesday, 18 February 2015 - 01:25
Xmega handheld programmer
If it as say in the manual. It will much better then Atmel AVRISP mkII. I just got some info that AVRISP mkII is going EOL CS
Monday, 9 February 2015 - 03:16

Pages