Post Created date
Programming via RS485 from Master Device to Slave Device
I am going to use M2560 as forwarding the firmware byte by byte to slaves. I have boot loader for M2560 and i have programmed via UART. I have following doubts.   1. How can...
Thursday, 18 February 2016 - 03:53
Flash WSN image to ATmega128RFA1,serial output is garbled
Hi alexru,           I don't have the STK600 base board. So i give power by some external own board we have.If it seems to high means, how much voltage i...
Wednesday, 24 September 2014 - 06:10
Flash WSN image to ATmega128RFA1,serial output is garbled
Hi,   I have two STk600-Atmega128RFA1 boards. i have programmed  one board, but i can't program the second one. While reading it shows " Unable to enter programming mode...
Wednesday, 17 September 2014 - 09:41
ATMega128RFA1 Data transmission without bitcloud
I want to use lightweight mesh to implement a co-ordinator ,router and end-device for 128rfa1.I found some code related to lightweight mesh in atmel website.But i am not sure on...
Thursday, 9 January 2014 - 08:32
ATMega128RFA1 Data transmission without bitcloud
Hi, I am using ATmega128RFA1 controller to establish a mesh network. can i establish a mesh network using this code?.can anyone suggest the method to assign a node as...
Tuesday, 26 November 2013 - 11:02