Type in the full discussion title or a part of it.
Discussion Title Created date
Macros
I don't normally use macros but others seem to use them to make configurating botloaders etc. easier. So I tried and failed. Is there any hope for me? In the following simple...
Saturday, 26 November 2011 - 16:48
Do you use Transient Voltage Suppressors?
I notice the Atmel Butterfly has TVS (varistors) on the RS232 RXD and TXD inputs. Does anybody else do this? .
Sunday, 12 June 2011 - 21:50
Possible expressPCB program enhancements?
The expressPCB program can highlight net connections. If I click on a pad, it shows me all the other pads that it should be connected to. It does this by reading the schematic....
Tuesday, 15 June 2010 - 11:39
Xmega PDI with JTAGICE mkii
I want to try using PDI with my Xmega and my JTAGICE mkii. I can make a cable using the squid. My JTAGICE has the correct hardware version. I've got AVR Studio version 4.18...
Wednesday, 2 June 2010 - 02:54
Can AVR Studio use the Xmega AVR911 bootloader?
I can't get it to work and I assume Studio doesn't support the Xmega bootloader. Why is that? It supports at least two bootloaders for the Mega. Maybe there is a way and I just...
Monday, 3 May 2010 - 17:49
I can't find the "AVR Studio demand list" thread, so I hope you will forgive me for posting here. :) Whenever I do a build, my makefile runs avr-size before and after the build.... Sunday, 2 May 2010 - 19:44
Xmega EEPROM curiousities
The EEPROM on my Xmega 128a1 rev. H chip on my Xplain board was pre-programmed. I expected it to contain only 0xff but that was not the case. Most of the EEPROM has alternating...
Sunday, 21 March 2010 - 02:01
The bit that Atmel forgot.
It would be nice if there was a global bit that would be turned on whenever an interrupt occurred. If you use a simple main loop and want to sleep when there is nothing to do,...
Thursday, 28 January 2010 - 15:10
Xmega ADC calibration value
The 12 bit calibration value for both ADCs on both of my Xplain boards is the same number, 0x0ff. If I had a suspicious mind, I would be suspicious. :) To be clear, that's CALH...
Monday, 25 January 2010 - 16:33
Prevent AVR Studio from loading program when using JTAG?
Sometimes I just want to use JTAG to debug a program that is already in the AVR rather than re-loading from the project. I asked this question 2 years ago and got an answer that...
Sunday, 27 December 2009 - 23:37
Xmega DFLL, does it work?
Does anyone know any magic words that makes it work? I have the Xmega 128a1 rev H and tried to use DFLL for the 2 MHz RC oscillator. It doesn't do anything.
Sunday, 27 December 2009 - 23:32
Xmega ultra low power oscillator (ULP)
I'm trying to figure out the Xmega clocks. I have come to the conclusion that the output of the ULP is 1 kHz, and only 1 kHz. The parts of the Xmega A datasheet that say...
Sunday, 20 December 2009 - 17:16

Pages