Post Created date
Dedicated PIC site.
PIC. Hm..... No suggestion.
Friday, 2 September 2011 - 19:11
AtTiny13V low battery monitor
In the circuit I gave you above and while the Vcc = BAT.V you could remove the NPN and the base resistor. Then you may connect the R2 of the voltage divider directly the Digital...
Friday, 2 September 2011 - 18:16
External interrupts on AT90CAN64, ASM, AVR studio. [solved]
By the way I didn't understand if the reset problem is fixed after the SPH and SPL initialization is added. ???
Friday, 2 September 2011 - 08:17
External interrupts on AT90CAN64, ASM, AVR studio. [solved]
Yura, I just said it again because you underlined this in your last post. regards,
Friday, 2 September 2011 - 08:16
AtTiny13V low battery monitor
Do you need low power consumption for the whole circuit? I guess you do. FUSE BITS: WDT_Off BOD_ON (1.8V) INT. RC 125KHz Convert this pseudocode to the language you are using: 1....
Friday, 2 September 2011 - 07:06
Decoupling caps
In the AVRFreaks forum section, while searching for a DALI aplication I found this: https://www.avrfreaks.net/modules... Looking at the second page, where the control circuit is...
Friday, 2 September 2011 - 05:55
External interrupts on AT90CAN64, ASM, AVR studio. [solved]
Yura, It says that if low consumption is needed during reset then connect anused pins to a pull-up or pull-down. Otherwise, you could simply set them as digital inputs with...
Friday, 2 September 2011 - 04:53
sensor???
First try to do this LED ---->>>> Data >>>>---- Sensor Nothing more. If you reed the data at the Vout pin of the sensor, then it means that the sensor works ok. Is it ok ?
Thursday, 1 September 2011 - 10:14
sensor???
Try to send a 38KHz encoded data. Send always 1ms (carrier 38 KHz) and 1 ms nothing. 1ms 1ms...
Thursday, 1 September 2011 - 09:52
Wireless entry and RFID.
I used the HTRC110 (Philips) and the EM4095 (EM Marine) in the past. Both of the are working in the range of 125KHz. If you think that you could get help from me then come back...
Thursday, 1 September 2011 - 07:52
sensor???
Details please...
Thursday, 1 September 2011 - 06:58
External interrupts on AT90CAN64, ASM, AVR studio. [solved]
Yura, Can you please tell me if after the STACK POINTER initialization the problem you had (RESET) still exists or not ? As for the Watchdog, it works like the similar peripheral...
Thursday, 1 September 2011 - 06:47

Pages