Type in the full discussion title or a part of it.
Discussion Title Created date
SIM 300C gsm/gprs modem datasheet
I can't find the SIM 300C gsm/gprs modem datasheet. Can anybody help? Michael.
Wednesday, 2 July 2008 - 07:26
Power Led strip heat trasfering suggestions
Hi there, I am on design state of a product using 6 power LEDs (1W). Unfortunately, the LEDs at 100% of luminocity produse high temperature level. There is no problem for us to...
Monday, 30 June 2008 - 12:30
rms current measurement on square signal
Hi there, Does anybody knows the formula for calculating the current flow through a resistanse, while a voltage source is a PWM. Known: 1. PWM Period 2. Duty Cycle 3. Resistor...
Wednesday, 25 June 2008 - 14:42
IAR-Cannot place data in EEPROM
Hi there, I don't know if this is the right forum for posting an IAR C compiler question, but I cannot see any other forum for posting. My problem is that I cannot place data in...
Friday, 13 June 2008 - 11:04
Save a programming project from AVR Studio
Hi there, I use to write a controller (on board) using the STK500 ISP connector. I load a hex file and then I set the fuse and lock bits. Is there any way to save those settings...
Thursday, 12 June 2008 - 10:44
AVRStudio 4.14.589 bug in watch window
Hi there, I don't know if this bug was in previous versions but it is the first time I see it. I have 2 functions in each one a local variable is defined with the same name. The...
Monday, 9 June 2008 - 09:59
ATtiny13V Debug wire problem
I found something, With these bits programed tha ATtiny13V cannot get in debuging mode. /* Fuse Bits */ // Debug Wire Enabled // Brown Out Detection at 1,8V // Clock divided by 8...
Friday, 6 June 2008 - 10:00
ATmega48V wakes up from power down unexpectable
Hi there, This is something I did it a lot of times using the ATtiny13V, but I cannot do it using the ATmega48V. I try to put the cpu in power down mode and to wake it up using...
Thursday, 5 June 2008 - 11:05
Switch to ATMega48P/V from ATMega48V
Hi there, I would like to switch to ATMega48P/V from ATMega48V. Is there something I have to do before do this to the production? Thanks, Michael.
Wednesday, 4 June 2008 - 08:36
ATmega48V and ATtiny13V question
Hi there, I have a very serious problem. A month ago I finished with a new designe that uses the ATtiny13V been supplied by mains power and when mains fail, by a rechargable...
Tuesday, 3 June 2008 - 15:14
LCD 4x20 (SPLC780D) question
Hi there, It's my first time I use a 4x20 character LCD. My problem is that I can't find the cursor position for each line start position. Can you help me? Michael
Sunday, 11 May 2008 - 19:00
ATmega48V ARef pin current
Hi there, I would like to know which is the minimum input current for the ARef pin for the ATmega48V. Reading the datasheet 2545M–AVR–09/07 at page 312, I found that the RREF...
Monday, 5 May 2008 - 13:34

Pages