Post Created date
Future Project research
Wow... way to go AtomicZombie
Wednesday, 20 October 2010 - 07:06
This makes no sense!
Ah I see thanks ig.
Sunday, 10 October 2010 - 18:57
This makes no sense!
Thanks for your reply Clint. I had gone through and read the datasheet and it does seem like its a very impressive opamp. Will it give you xx.xx accuracy or higher? Thanks ig, I...
Sunday, 10 October 2010 - 03:16
This makes no sense!
I've been trying to get started in a project to make a pH meter for my aquarium for the longest time. I know so little about op amps so I'm curious why the LMC6001? From the info...
Thursday, 7 October 2010 - 03:25
Soldering and SMD
Flux should be cleaned with isopropyl alcohol right? Thanks all for your input
Monday, 13 September 2010 - 07:51
Soldering and SMD
I don't think I've ran into the jelly flux. I'm using a liquid flux rosin which has helped but can be a bit messy. It makes my fingertips incredibly sticky. Thanks for the advice...
Sunday, 12 September 2010 - 20:01
Whats a good way to turn off TWI ICs to save battery life?
Its not a specific IC that will be pulling lots of power. I was just curious how such things were acomplished. Thanks for those suggestions. I am contemplating not having any...
Tuesday, 24 August 2010 - 05:39
[TUT] I2C Bus for ATtiny and ATmega
I really enjoyed your tutorial doctek. I've read instructables for over a year and never signed up until yours.
Monday, 16 August 2010 - 09:27
Sharing SPI with both SD and ISP?
Thank you both for you inputs. I'm going to read over the documents you've mentioned Mike B. On all the circuits that I've seen for interfacing an AVR with an SD card all the SPI...
Monday, 2 February 2009 - 09:32
Step-down DC-DC options , need advice
djoshi wrote:Bypass caps, are same de-coupling caps? Just place them between VCC and GND of all devices DJ Yup, I've been told the common value is a ceramic .1uF cap. Wikipedia...
Wednesday, 13 August 2008 - 11:54
What is this FET doing? (new question)
Kartman wrote:The volts always want to find themselves a path back to 0V (ground) and as Micro explains, you can get 'sneak' paths - that is currents flowing in places you didn't...
Tuesday, 12 August 2008 - 15:59
What is this FET doing? (new question)
Thanks a lot for your comments Jani and Micro! Since I really need only 4 pins to plug in I will look into using a USB plug itself if possible. I also have a better idea of what I...
Saturday, 9 August 2008 - 11:59

Pages