Type in the full discussion title or a part of it.
Discussion Title Created date
AS 7.0.1188 installation issues
Just got a new HP Pavillion I-7 computer.   Down loaded Arduino ide    got that working. Tried to install AS 7.0  version 7.0.1188.   clicking on the...
Wednesday, 4 January 2017 - 01:41
PWM/Servo on 32u4
I have an Adafruit 32u4 breakout board. I'm using Studio 6.1 (External Tools) to flash the board. I believe the board runs at 16Hz. When I set up the code as shown below to...
Friday, 22 November 2013 - 15:38
'DDRB' was not declared in this scope, Studio 6.1
I just installed 6.1 and tried to build a simple program for a 32u4 uc. I get the above error as well as Error 'DDB0' was not declared in this scope I'm guessing this is a set...
Thursday, 2 May 2013 - 01:54
Use or Not Use Interrupts
My project includes a 324P to drive two servos , flash some leds depending on the position of the servos and display to a LCD information concerning servo position, etc....
Monday, 18 April 2011 - 17:03
Touchshield slide without Arduino?
Has anyone written any C code to interface with the Touchshield Slide? There are a couple of nice programs for the Slide but all seem to be designed for the Arduino. I don't...
Friday, 13 August 2010 - 14:30
Toggling too quickly to turn off PB4 on (OC0B)?
PB0 and PB4 are both tied to a separate TIP 51 transistor (no signifiant load yet just a indicator led tied to transistor). PB0 is a steady led, PB3 and PB4 flashes from a 8...
Wednesday, 27 January 2010 - 04:42
XBEE and Atmega
I have the USART set up on a 324P chip. When I have the chip on the STK 500 I can send a single letter and the chip responds to code and I receive the same letter as confirmation...
Saturday, 23 January 2010 - 07:14
EEPROM Issue
I'm trying to put some values in eeprom that can be change at start up if needed. Otherwise at startup the old values will be used. I'm getting some errors and I not sure what I...
Monday, 18 January 2010 - 17:17
ADC on Servo
I have 2 servo running off a Atemga 324p to operate toy gates, considering I had a few spare pins after the limit switches and lights were hooked up. I was considering setting up...
Monday, 18 January 2010 - 00:43
USART not communicating with hyperterminal
I'm having trouble getting feed back on the Hyperterminal using USART. I have the hyperterminal set for 4800 and I can see the led on the cable usb blink whenever I send a...
Friday, 1 January 2010 - 03:17
Xbee-AVR communication and code
I plan to set up an Atmega32 to drive servo's and some leds. I ordered 2 xbees with the 5v to 3.3v converter. It would be cool to operate the system remotely from the computer....
Thursday, 31 December 2009 - 02:36
Servo's Last Position
I've got 2 servos operating on an Atmega32 using 16-bit mode. Initially I set the position in the center, then move them clockwise or counterclockwise. In the final application...
Wednesday, 23 December 2009 - 17:12

Pages