Post Created date
16Bit Binary to Ascii
Try this... ; .device ATmega88 _16bitToAscii: .def tenThousPlace = r19 .def thousPlace = r20 .def hundPlace = r21 .def tensPlace = r22 .def onesPlace = r23 .def numL = r24 ....
Thursday, 3 May 2012 - 17:29
USART problem
Quote:i set the clock to 7.3728MHz using the frequency setting in the project configuration menu of AVR Studio 4. Adjusting the settings in AVR Studio only has an affect on the...
Tuesday, 27 September 2011 - 02:45
Ulrasonic sensor circuit
Try this link www.kerrywong.com. He has schematics, code, and a write up.
Friday, 25 February 2011 - 23:52
using branch instructions
You can branch to a call, icall, rcall, jmp, ijmp, or rjmp to extend the the reach.
Tuesday, 22 February 2011 - 09:03
Converting a momentary switch to latching control
If using one of the modern AVR's with the pin toggle feature, can't he just write a logical 1 to the PINxN after debouncing and determining the switch has been pressed? This keeps...
Tuesday, 7 December 2010 - 22:27
(solved, thanks) CTC, clear OC0A1 on compare match
Sorry. I did use Ctrl-C/Ctrl-L. When I previewed the code the comments made the code harder to read so I tried to shorten them. I deleted some of the code and retyped it. I will...
Monday, 6 September 2010 - 17:48
(solved, thanks) CTC, clear OC0A1 on compare match
(1<<ocoa1) should be (1<<com0a1). That's how I had it in the original code, messed it up after posting it over here. Thanks for pointing that out. Mike B, I get what...
Monday, 6 September 2010 - 12:04
How to control Servo motor on pins other than OC1A or OC1B
You have to use software PWM. Seatle Robot Society has some example code. I have a project on this site that uses a software/hardware approach. The basic algorithm is this: Set...
Monday, 9 August 2010 - 13:44
Screw you! metric or imperial?
Most hobby shops have good supply of metric fasteners. I use them all the time in my RC cars and helicopter.
Thursday, 27 May 2010 - 22:21
control multi servo
Futaba or Hitec?
Wednesday, 17 February 2010 - 23:40
Temperature measurement and PC data processing
If you're still needing to sense a flame, you can use a flame sensor from a gas furnace. These can be picked up at. Talk to a local HVAC guy about getting you one or just go to an...
Monday, 9 February 2009 - 03:15
Serial Communication among AVR's with least number of wires
Tashrifahmed, I had a same problem. You're right it is a synchronization problem. If you use Bray's Terminal you can view the bytes as binary. Char.....Binary B........01000001...
Thursday, 9 November 2006 - 16:53

Pages